Hi Aleksander,
On Tue, Oct 12, 2021 at 09:38:41PM +0200, Aleksander Morgado wrote:
> Hey
>
[...]
> The successful boots seem to happen always on cold boots, and the
> success rate is low (30% or so) on some manual testing here. I haven't
> seen one single successful boot on system restarts, they all fail like
> in the previous email.
>
> When the boot is successful it looks like this:
>
This looks to be a firmware issue. The device is in SYS_ERR state during
boot and that's expected. But what is strange is that the device stays
in SYS_ERR even after host issues RESET.
Can you try the below diff and see if it does any good?
diff --git a/drivers/bus/mhi/core/pm.c b/drivers/bus/mhi/core/pm.c
index fb99e3727155..a43c3ed77fb1 100644
--- a/drivers/bus/mhi/core/pm.c
+++ b/drivers/bus/mhi/core/pm.c
@@ -104,7 +104,8 @@ static struct mhi_pm_transitions const dev_state_transitions[] = {
/* L3 States */
{
MHI_PM_LD_ERR_FATAL_DETECT,
- MHI_PM_LD_ERR_FATAL_DETECT | MHI_PM_DISABLE
+ MHI_PM_LD_ERR_FATAL_DETECT | MHI_PM_DISABLE |
+ MHI_PM_SYS_ERR_PROCESS
},
};
Thanks,
Mani
> [ 0.099938] brcm-pcie fd500000.pcie: host bridge /scb/pcie@7d500000 ranges:
> [ 0.099961] brcm-pcie fd500000.pcie: No bus range found for
> /scb/pcie@7d500000, using [bus 00-ff]
> [ 0.099999] brcm-pcie fd500000.pcie: MEM
> 0x0600000000..0x0603ffffff -> 0x00f8000000
> [ 0.100032] brcm-pcie fd500000.pcie: IB MEM
> 0x0000000000..0x00bfffffff -> 0x0000000000
> [ 0.149955] brcm-pcie fd500000.pcie: link up, 5 GT/s x1 (SSC)
> [ 0.150114] brcm-pcie fd500000.pcie: PCI host bridge to bus 0000:00
> [ 0.150133] pci_bus 0000:00: root bus resource [bus 00-ff]
> [ 0.150152] pci_bus 0000:00: root bus resource [mem
> 0x600000000-0x603ffffff] (bus address [0xf8000000-0xfbffffff])
> [ 0.150193] pci 0000:00:00.0: [14e4:2711] type 01 class 0x060400
> [ 0.150282] pci 0000:00:00.0: PME# supported from D0 D3hot
> [ 0.153464] pci 0000:00:00.0: bridge configuration invalid ([bus
> ff-ff]), reconfiguring
> [ 0.153589] pci 0000:01:00.0: [17cb:0306] type 00 class 0xff0000
> [ 0.153650] pci 0000:01:00.0: reg 0x10: [mem 0x00000000-0x00000fff 64bit]
> [ 0.153680] pci 0000:01:00.0: reg 0x18: [mem 0x00000000-0x00000fff 64bit]
> [ 0.153838] pci 0000:01:00.0: PME# supported from D0 D3hot D3cold
> [ 0.153889] pci 0000:01:00.0: 4.000 Gb/s available PCIe bandwidth,
> limited by 5 GT/s x1 link at 0000:00:00.0 (capable of 31.506 Gb/s with
> 16 GT/s x2 link)
> [ 0.156944] pci_bus 0000:01: busn_res: [bus 01-ff] end is updated to 01
> [ 0.156983] pci 0000:00:00.0: BAR 8: assigned [mem 0x600000000-0x6000fffff]
> [ 0.157004] pci 0000:01:00.0: BAR 0: assigned [mem
> 0x600000000-0x600000fff 64bit]
> [ 0.157035] pci 0000:01:00.0: BAR 2: assigned [mem
> 0x600001000-0x600001fff 64bit]
> [ 0.157064] pci 0000:00:00.0: PCI bridge to [bus 01]
> [ 0.157079] pci 0000:00:00.0: bridge window [mem 0x600000000-0x6000fffff]
> [ 0.157222] pcieport 0000:00:00.0: enabling device (0000 -> 0002)
> [ 0.157340] pcieport 0000:00:00.0: PME: Signaling with IRQ 38
> [ 0.157567] pcieport 0000:00:00.0: AER: enabled with IRQ 38
> [ 7.052080] mhi-pci-generic 0000:01:00.0: MHI PCI device found: sierra-em919x
> [ 7.059284] mhi-pci-generic 0000:01:00.0: BAR 0: assigned [mem
> 0x600000000-0x600000fff 64bit]
> [ 7.067839] mhi-pci-generic 0000:01:00.0: enabling device (0000 -> 0002)
> [ 7.074676] mhi-pci-generic 0000:01:00.0: using shared MSI
> [ 7.080858] mhi mhi0: Requested to power ON
> [ 7.085357] mhi mhi0: Attempting power on with EE: PASS THROUGH,
> state: SYS ERROR
> [ 7.431361] mhi mhi0: local ee: INVALID_EE state: RESET device ee:
> PASS THROUGH state: RESET
> [ 7.432247] mhi mhi0: Power on setup success
> [ 7.440015] mhi mhi0: Handling state transition: PBL
> [ 8.387907] mhi mhi0: Device in READY State
> [ 8.392128] mhi mhi0: Initializing MHI registers
> [ 8.396815] mhi mhi0: Wait for device to enter SBL or Mission mode
> [ 14.148059] mhi mhi0: State change event to state: M0
> [ 14.148076] mhi mhi0: local ee: PASS THROUGH state: READY device
> ee: MISSION MODE state: M0
> [ 14.161518] mhi mhi0: Received EE event: MISSION MODE
> [ 14.161522] mhi mhi0: local ee: PASS THROUGH state: M0 device ee:
> MISSION MODE state: M0
> [ 14.174684] mhi mhi0: Handling state transition: MISSION MODE
> [ 14.180447] mhi mhi0: Processing Mission Mode transition
> [ 14.186199] mhi_net mhi0_IP_HW0: 100: Updating channel state to: START
> [ 14.361842] mhi mhi0: local ee: MISSION MODE state: M0 device ee:
> MISSION MODE state: M0
> [ 14.363918] mhi_net mhi0_IP_HW0: 100: Channel state change to START
> successful
> [ 14.377324] mhi_net mhi0_IP_HW0: 101: Updating channel state to: START
> [ 14.490249] mhi_net mhi0_IP_HW0: 101: Channel state change to START
> successful
> [ 14.490255] mhi mhi0: local ee: MISSION MODE state: M0 device ee:
> MISSION MODE state: M0
> [ 16.835372] mhi mhi0: Allowing M3 transition
> [ 16.839695] mhi mhi0: Waiting for M3 completion
> [ 16.966594] mhi mhi0: State change event to state: M3
> [ 16.966615] mhi mhi0: local ee: MISSION MODE state: M0 device ee:
> MISSION MODE state: M3
> [ 20.460243] mhi_wwan_ctrl mhi0_DUN: 32: Updating channel state to: START
> [ 20.484117] mhi mhi0: Entered with PM state: M3, MHI state: M3
> [ 20.499999] mhi mhi0: State change event to state: M0
> [ 20.500021] mhi mhi0: local ee: MISSION MODE state: M3 device ee:
> MISSION MODE state: M0
> [ 20.517791] mhi mhi0: local ee: MISSION MODE state: M0 device ee:
> MISSION MODE state: M0
> ....
>
> When in this state, ModemManager/qmicli/mbimcli can pick up the device
> right away, without any issues observed there. Haven't tested data
> connection yet.
>
> root@OpenWrt:~# mmcli -m 0
> -----------------------------
> General | path: /org/freedesktop/ModemManager1/Modem/0
> | device id: 58a66d754412bf0a8ec2a840f111856d85a4b053
> -----------------------------
> Hardware | manufacturer: Sierra Wireless, Incorporated
> | model: EM9191
> | firmware revision: SWIX55C_02.08.01.00 58f60e jenkins
> 2021/03/12 18:05:48
> | carrier config: default
> | h/w revision: 0.2
> | supported: gsm-umts, lte, 5gnr
> | current: gsm-umts, lte, 5gnr
> | equipment id: XXXXXXXXXXXXXX
> -----------------------------
> System | device:
> /sys/devices/platform/scb/fd500000.pcie/pci0000:00/0000:00:00.0/0000:01:00.0
> | drivers: mhi-pci-generic, mhi_net
> | plugin: generic
> | primary port: wwan0qmi0
> | ports: mhi_hwip0 (net), wwan0at0 (at),
> wwan0mbim0 (mbim),
> | wwan0qcdm0 (qcdm), wwan0qmi0 (qmi)
> -----------------------------
> Status | state: failed
> | failed reason: sim-missing
> | power state: on
> | signal quality: 0% (cached)
> -----------------------------
> Modes | supported: allowed: 3g; preferred: none
> | allowed: 4g; preferred: none
> | allowed: 3g, 4g; preferred: 4g
> | allowed: 3g, 4g; preferred: 3g
> | allowed: 5g; preferred: none
> | allowed: 3g, 5g; preferred: 5g
> | allowed: 3g, 5g; preferred: 3g
> | allowed: 4g, 5g; preferred: 5g
> | allowed: 4g, 5g; preferred: 4g
> | allowed: 3g, 4g, 5g; preferred: 5g
> | allowed: 3g, 4g, 5g; preferred: 4g
> | allowed: 3g, 4g, 5g; preferred: 3g
> | current: allowed: any; preferred: none
> -----------------------------
> Bands | supported: utran-1, utran-3, utran-4, utran-6,
> utran-5, utran-8,
> | utran-9, utran-2, eutran-1, eutran-2,
> eutran-3, eutran-4, eutran-5,
> | eutran-7, eutran-8, eutran-12,
> eutran-13, eutran-14, eutran-17,
> | eutran-18, eutran-19, eutran-20,
> eutran-25, eutran-26, eutran-28,
> | eutran-29, eutran-30, eutran-32,
> eutran-34, eutran-38, eutran-39,
> | eutran-40, eutran-41, eutran-42,
> eutran-46, eutran-48, eutran-66,
> | eutran-71, utran-19
> -----------------------------
> IP | supported: ipv4, ipv6, ipv4v6
> -----------------------------
> SIM | sim slot paths: slot 1: none (active)
>
> root@OpenWrt:~# qmicli -d /dev/wwan0qmi0 -p --dms-get-capabilities
> [/dev/wwan0qmi0] Device capabilities retrieved:
> Max TX channel rate: '50000000'
> Max RX channel rate: '100000000'
> Data Service: 'non-simultaneous-cs-ps'
> SIM: 'supported'
> Networks: 'umts, lte, 5gnr'
>
> root@OpenWrt:~# mbimcli -d /dev/wwan0mbim0 -p --query-device-caps
> [/dev/wwan0mbim0] Device capabilities retrieved:
> Device type: 'embedded'
> Cellular class: 'gsm'
> Voice class: 'no-voice'
> SIM class: 'removable'
> Data class: 'umts, hsdpa, hsupa, lte, custom'
> SMS caps: 'pdu-receive, pdu-send'
> Ctrl caps: 'reg-manual'
> Max sessions: '15'
> Custom data class: '5G/TDS'
> Device ID: 'XXXXXXXXXXX'
> Firmware info: '02.08.01.00_GENERI_020.007_001'
> Hardware info: 'EM9191'
>
> --
> Aleksander
> https://aleksander.es
