GPI DMA is one of the DMA modes supported on geni, this adds support to enable that mode Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx> --- drivers/soc/qcom/qcom-geni-se.c | 32 +++++++++++++++++++++++++++++++- include/linux/qcom-geni-se.h | 5 +++-- 2 files changed, 34 insertions(+), 3 deletions(-) diff --git a/drivers/soc/qcom/qcom-geni-se.c b/drivers/soc/qcom/qcom-geni-se.c index 08d645b90ed3..40a0a1f88070 100644 --- a/drivers/soc/qcom/qcom-geni-se.c +++ b/drivers/soc/qcom/qcom-geni-se.c @@ -307,6 +307,32 @@ static void geni_se_select_dma_mode(struct geni_se *se) writel_relaxed(val, se->base + SE_GENI_DMA_MODE_EN); } +static void geni_se_select_gpi_mode(struct geni_se *se) +{ + unsigned int gpi_event_en; + unsigned int m_irq_en; + unsigned int s_irq_en; + + geni_se_irq_clear(se); + writel(0, se->base + SE_IRQ_EN); + + s_irq_en = readl_relaxed(se->base + SE_GENI_S_IRQ_EN); + s_irq_en &= ~S_CMD_DONE_EN; + writel(s_irq_en, se->base + SE_GENI_S_IRQ_EN); + + m_irq_en = readl(se->base + SE_GENI_M_IRQ_EN); + m_irq_en &= ~(M_CMD_DONE_EN | M_TX_FIFO_WATERMARK_EN | + M_RX_FIFO_WATERMARK_EN | M_RX_FIFO_LAST_EN); + writel(m_irq_en, se->base + SE_GENI_M_IRQ_EN); + + writel(GENI_DMA_MODE_EN, se->base + SE_GENI_DMA_MODE_EN); + + gpi_event_en = readl(se->base + SE_GSI_EVENT_EN); + gpi_event_en |= (DMA_RX_EVENT_EN | DMA_TX_EVENT_EN | + GENI_M_EVENT_EN | GENI_S_EVENT_EN); + writel(gpi_event_en, se->base + SE_GSI_EVENT_EN); +} + /** * geni_se_select_mode() - Select the serial engine transfer mode * @se: Pointer to the concerned serial engine. @@ -314,7 +340,8 @@ static void geni_se_select_dma_mode(struct geni_se *se) */ void geni_se_select_mode(struct geni_se *se, enum geni_se_xfer_mode mode) { - WARN_ON(mode != GENI_SE_FIFO && mode != GENI_SE_DMA); + WARN_ON(mode != GENI_SE_FIFO && mode != GENI_SE_DMA && + mode != GENI_GPI_DMA); switch (mode) { case GENI_SE_FIFO: @@ -323,6 +350,9 @@ void geni_se_select_mode(struct geni_se *se, enum geni_se_xfer_mode mode) case GENI_SE_DMA: geni_se_select_dma_mode(se); break; + case GENI_GPI_DMA: + geni_se_select_gpi_mode(se); + break; case GENI_SE_INVALID: default: break; diff --git a/include/linux/qcom-geni-se.h b/include/linux/qcom-geni-se.h index 5fda675c5cfe..336b682392b1 100644 --- a/include/linux/qcom-geni-se.h +++ b/include/linux/qcom-geni-se.h @@ -11,8 +11,9 @@ /* Transfer mode supported by GENI Serial Engines */ enum geni_se_xfer_mode { GENI_SE_INVALID, - GENI_SE_FIFO, - GENI_SE_DMA, + GENI_SE_FIFO, /* FIFO mode */ + GENI_GPI_DMA, /* GSI aka GPI DMA mode */ + GENI_SE_DMA, /* SE DMA mode */ }; /* Protocols supported by GENI Serial Engines */ -- 2.31.1