On 3/19/21 2:15 PM, Ansuel Smith wrote:
Device based on tsens VER_0 contains a hardware bug that results in some
problem with sensor enablement. Sensor id 6-11 can't be enabled
selectively and all of them must be enabled in one step.
Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
Acked-by: Thara Gopinath <thara.gopinath@xxxxxxxxxx>
Warm Regards
Thara
---
drivers/thermal/qcom/tsens-8960.c | 23 ++++++++++++++++++++---
1 file changed, 20 insertions(+), 3 deletions(-)
diff --git a/drivers/thermal/qcom/tsens-8960.c b/drivers/thermal/qcom/tsens-8960.c
index 86585f439985..bf8dfaf06428 100644
--- a/drivers/thermal/qcom/tsens-8960.c
+++ b/drivers/thermal/qcom/tsens-8960.c
@@ -27,9 +27,9 @@
#define EN BIT(0)
#define SW_RST BIT(1)
#define SENSOR0_EN BIT(3)
+#define MEASURE_PERIOD BIT(18)
#define SLP_CLK_ENA BIT(26)
#define SLP_CLK_ENA_8660 BIT(24)
-#define MEASURE_PERIOD 1
#define SENSOR0_SHIFT 3
/* INT_STATUS_ADDR bitmasks */
@@ -126,17 +126,34 @@ static int resume_8960(struct tsens_priv *priv)
static int enable_8960(struct tsens_priv *priv, int id)
{
int ret;
- u32 reg, mask;
+ u32 reg, mask = BIT(id);
ret = regmap_read(priv->tm_map, CNTL_ADDR, ®);
if (ret)
return ret;
- mask = BIT(id + SENSOR0_SHIFT);
+ /* HARDWARE BUG:
+ * On platform with more than 6 sensors, all the remaining
+ * sensors needs to be enabled all togheder or underfined
+ * results are expected. (Sensor 6-7 disabled, Sensor 3
+ * disabled...) In the original driver, all the sensors
+ * are enabled in one step hence this bug is not triggered.
+ */
+ if (id > 5)
+ mask = GENMASK(10, 6);
+
+ mask <<= SENSOR0_SHIFT;
+
+ /* Sensors already enabled. Skip. */
+ if ((reg & mask) == mask)
+ return 0;
+
ret = regmap_write(priv->tm_map, CNTL_ADDR, reg | SW_RST);
if (ret)
return ret;
+ reg |= MEASURE_PERIOD;
+
if (priv->num_sensors > 1)
reg |= mask | SLP_CLK_ENA | EN;
else
