Hi,
On Mon, Jan 11, 2021 at 7:18 AM Vinod Koul <vkoul@xxxxxxxxxx> wrote:
>
> @@ -2622,6 +2626,13 @@ pinmux {
> "gpio2", "gpio3";
> function = "qup0";
> };
> +
> + config {
Convention in Qualcomm device tree files seems to be that the node is
"pinconf", not "config".
> + pins = "gpio0", "gpio1",
> + "gpio2", "gpio3";
> + drive-strength = <6>;
> + bias-disable;
> + };
Pin config almost never belongs in the SoC dtsi file. This should be
in the board .dts file. What if pulls are needed on some pins? What
if you need a stronger or weaker drive strength?
-Doug
