Add IOMMU nodes to QUP devices on SM8250. Without this the board will
reboot on when I2C DMA transfers are used.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sm8250.dtsi | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sm8250.dtsi b/arch/arm64/boot/dts/qcom/sm8250.dtsi
index 3170a612f65f..6d00cab1553d 100644
--- a/arch/arm64/boot/dts/qcom/sm8250.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8250.dtsi
@@ -467,6 +467,7 @@ qupv3_id_2: geniqup@8c0000 {
<&gcc GCC_QUPV3_WRAP_2_S_AHB_CLK>;
#address-cells = <2>;
#size-cells = <2>;
+ iommus = <&apps_smmu 0x63 0x0>;
ranges;
status = "disabled";
@@ -673,6 +674,7 @@ qupv3_id_0: geniqup@9c0000 {
<&gcc GCC_QUPV3_WRAP_0_S_AHB_CLK>;
#address-cells = <2>;
#size-cells = <2>;
+ iommus = <&apps_smmu 0x5a3 0x0>;
ranges;
status = "disabled";
@@ -935,6 +937,7 @@ qupv3_id_1: geniqup@ac0000 {
<&gcc GCC_QUPV3_WRAP_1_S_AHB_CLK>;
#address-cells = <2>;
#size-cells = <2>;
+ iommus = <&apps_smmu 0x43 0x0>;
ranges;
status = "disabled";
--
2.28.0
