On Thu, 09 Jul 2020 23:51:33 +0200, Ansuel Smith wrote: > Document the use of regmap phandle for ipq8064 SoCs > > Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx> > --- > .../bindings/thermal/qcom-tsens.yaml | 51 ++++++++++++++++--- > 1 file changed, 44 insertions(+), 7 deletions(-) > My bot found errors running 'make dt_binding_check' on your patch: Documentation/devicetree/bindings/thermal/qcom-tsens.example.dts:21.38-31.11: Warning (unit_address_vs_reg): /example-0/thermal-sensor@900000: node has a unit name, but no reg or ranges property /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: interrupts: [[0, 178, 4]] is too short /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: '#qcom,sensors' is a required property /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: 'interrupt-names' is a required property /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible: ['qcom,ipq8064-tsens'] is not valid under any of the given schemas (Possible causes of the failure): /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible: ['qcom,ipq8064-tsens'] is too short /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible:0: 'qcom,ipq8064-tsens' is not one of ['qcom,msm8976-tsens', 'qcom,qcs404-tsens'] /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible:0: 'qcom,ipq8064-tsens' is not one of ['qcom,msm8996-tsens', 'qcom,msm8998-tsens', 'qcom,sc7180-tsens', 'qcom,sdm845-tsens'] /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: nvmem-cell-names:1: 'calib_sel' was expected See https://patchwork.ozlabs.org/patch/1326228 If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure dt-schema is up to date: pip3 install git+https://github.com/devicetree-org/dt-schema.git@master --upgrade Please check and re-submit.
