On 6/25/2020 10:38 AM, Bjorn Andersson wrote:
On Mon 15 Jun 05:02 PDT 2020, Rajendra Nayak wrote:
geni serial needs to express a perforamnce state requirement on CX
powerdomain depending on the frequency of the clock rates.
Use OPP table from DT to register with OPP framework and use
dev_pm_opp_set_rate() to set the clk/perf state.
Signed-off-by: Rajendra Nayak <rnayak@xxxxxxxxxxxxxx>
Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Cc: Akash Asthana <akashast@xxxxxxxxxxxxxx>
Cc: linux-serial@xxxxxxxxxxxxxxx
Picked up patch 1 and 2 through the qcom tree.
thanks Bjorn
As Mark requested, please don't lump together patches that doesn't
actually depend on each other in the same series - it's quite confusing
to know what to pick and not.
Sorry for the confusion, I will try and split them into driver specific patches henceforth.
For this series though, I see that you have merged the entire ICC series for
QUP and QSPI into for-next of the qcom tree.
In which case it perhaps makes sense for you to pull in the QSPI change from this series
as well? i.e PATCH 6/6.
If so, I will rebase the patch on your for-next and resend (Its already Ack'ed by Mark)
thanks,
Rajendra
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
