Hello,
On Fri, 5 Jun 2020 at 07:40, Vinod Koul <vkoul@xxxxxxxxxx> wrote:
>
>
> Sorry missed ccing Amit, done now.
>
> On 04-06-20, 18:03, Dmitry Baryshkov wrote:
> > On 04/06/2020 13:47, Vinod Koul wrote:
> > > On 04-06-20, 03:43, Dmitry Baryshkov wrote:
>
> > > > pm8150_adc: adc@3100 {
> > > > compatible = "qcom,spmi-adc5";
> > > > reg = <0x3100>;
> > > > @@ -38,8 +47,6 @@ pm8150_adc: adc@3100 {
> > > > #io-channel-cells = <1>;
> > > > interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
> > > > - status = "disabled";
> > > > -
> > >
> > > This should not be removed, rather than this please add enabled in you
> > > board dts file
Compare this with pm8998.dtsi. It has all nodes enabled by default.
> > > > +&thermal_zones {
> > > > + pm8150_temp {
> > > > + polling-delay-passive = <0>;
> > > > + polling-delay = <0>;
> > > > +
> > > > + thermal-sensors = <&pm8150_temp>;
> > > > +
> > > > + trips {
> > > > + trip0 {
> > > > + temperature = <95000>;
> > > > + hysteresis = <0>;
> > > > + type = "passive";
> > > > + };
> > > > +
> > > > + trip1 {
> > > > + temperature = <115000>;
> > > > + hysteresis = <0>;
> > > > + type = "passive";
> > > > + };
> > > > +
> > > > + trip2 {
> > > > + temperature = <145000>;
> > > > + hysteresis = <0>;
> > > > + type = "passive";
> > > > + };
> > > > + };
> > > > +
> > > > + };
> > >
> > > Not sure about this, Amit..? Should this also not be in board dts?
> > >
> > > Similar comments on similar ones for rest of the patch as well..
> >
> > I'm not so sure. This part of the configuration seems generic to me. Unlike
> > adc-tm config, which definitely goes to the board file.
>
> I think the temperature values may be board specific, Amit can confirm
> that. If that is the case then this belongs to board dts, otherwise here :)
Again, pm8998 has these thermal values in the dtsi file. In V2 I will
update these three files to follow pm8998.dtsi.
--
With best wishes
Dmitry
