On 6/4/20 11:58 AM, Manivannan Sadhasivam wrote:
On Thu, Jun 04, 2020 at 10:06:19AM -0400, Jonathan Marek wrote:
On 6/4/20 9:52 AM, Manivannan Sadhasivam wrote:
Hi,
On Sat, May 23, 2020 at 10:38:06PM -0400, Jonathan Marek wrote:
Add dts nodes for apps_smmu and USB for both sm8150 and sm8250.
I've tested this series on an SM8250 based board and able to get Type C (USB0)
working. There are also couple of Type A ports (USB1) on that board behind a
USB hub. It is probing fine but I don't see any activity while connecting a
USB device. Will continue to debug and once I get them working, I'll add my
Tested-by tag.
HDK865 also has a couple Type A ports, I am using them with devices already
plugged in during boot and I haven't hit a problem like that, but I think
I've seen the same issue when hotplugging. IIRC the behavior was a bit
weird, like plugging a device in the Type A port (USB1) nothing would
happen, but unplugging/replugging the type C port (USB0) would cause the
Type A port device to start working..
Have you tried with the devices already plugged in before booting?
Tried it but no luck :/ Also plugging and removing Type C doesn't make any
difference.
This one might be obvious, but do you have 5V power coming out of the
type A ports?
Thanks,
Mani
Thanks,
Mani
Also add initial dts files for HDK855 and HDK865, based on mtp dts, with a
few changes. Notably, the HDK865 dts has regulator config changed a bit based
on downstream (I think sm8250-mtp.dts is wrong and copied too much from sm8150).
Jonathan Marek (6):
arm64: dts: qcom: sm8150: add apps_smmu node
arm64: dts: qcom: sm8250: add apps_smmu node
arm64: dts: qcom: sm8150: Add secondary USB and PHY nodes
arm64: dts: qcom: sm8250: Add USB and PHY device nodes
arm64: dts: qcom: add sm8150 hdk dts
arm64: dts: qcom: add sm8250 hdk dts
arch/arm64/boot/dts/qcom/Makefile | 2 +
arch/arm64/boot/dts/qcom/sm8150-hdk.dts | 461 ++++++++++++++++++++++++
arch/arm64/boot/dts/qcom/sm8150.dtsi | 180 +++++++++
arch/arm64/boot/dts/qcom/sm8250-hdk.dts | 454 +++++++++++++++++++++++
arch/arm64/boot/dts/qcom/sm8250.dtsi | 287 +++++++++++++++
5 files changed, 1384 insertions(+)
create mode 100644 arch/arm64/boot/dts/qcom/sm8150-hdk.dts
create mode 100644 arch/arm64/boot/dts/qcom/sm8250-hdk.dts
--
2.26.1
