Hi, On Sat, May 23, 2020 at 10:38:06PM -0400, Jonathan Marek wrote: > Add dts nodes for apps_smmu and USB for both sm8150 and sm8250. > I've tested this series on an SM8250 based board and able to get Type C (USB0) working. There are also couple of Type A ports (USB1) on that board behind a USB hub. It is probing fine but I don't see any activity while connecting a USB device. Will continue to debug and once I get them working, I'll add my Tested-by tag. Thanks, Mani > Also add initial dts files for HDK855 and HDK865, based on mtp dts, with a > few changes. Notably, the HDK865 dts has regulator config changed a bit based > on downstream (I think sm8250-mtp.dts is wrong and copied too much from sm8150). > > Jonathan Marek (6): > arm64: dts: qcom: sm8150: add apps_smmu node > arm64: dts: qcom: sm8250: add apps_smmu node > arm64: dts: qcom: sm8150: Add secondary USB and PHY nodes > arm64: dts: qcom: sm8250: Add USB and PHY device nodes > arm64: dts: qcom: add sm8150 hdk dts > arm64: dts: qcom: add sm8250 hdk dts > > arch/arm64/boot/dts/qcom/Makefile | 2 + > arch/arm64/boot/dts/qcom/sm8150-hdk.dts | 461 ++++++++++++++++++++++++ > arch/arm64/boot/dts/qcom/sm8150.dtsi | 180 +++++++++ > arch/arm64/boot/dts/qcom/sm8250-hdk.dts | 454 +++++++++++++++++++++++ > arch/arm64/boot/dts/qcom/sm8250.dtsi | 287 +++++++++++++++ > 5 files changed, 1384 insertions(+) > create mode 100644 arch/arm64/boot/dts/qcom/sm8150-hdk.dts > create mode 100644 arch/arm64/boot/dts/qcom/sm8250-hdk.dts > > -- > 2.26.1 >
