Re: [RFC-v2 0/2] Add Support for SDHC bus bandwidth voting

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Pradeep,

what is the status of this series, do you plan to send v3 soon or
is it abandonded?

Thanks

Matthias

On Fri, Nov 08, 2019 at 07:08:37PM +0530, Pradeep P V K wrote:
> Vote for the MSM bus bandwidth required by SDHC driver
> based on the clock speed and bus width of the card.
> Otherwise, the system clocks may run at minimum clock
> speed and thus affecting the performance.
> 
> Adapt to the new ICB framework for bus bandwidth voting.
> 
> This requires the source/destination port ids.
> Also this requires a tuple of values.
> 
> The tuple is for two different paths - from SDHC master
> to BIMC slave. The other is from CPU master to SDHC slave.
> This tuple consists of the average and peak bandwidth.
> 
> This change is based on Georgi Djakov [RFC]
> (https://lkml.org/lkml/2018/10/11/499)
> 
> ---
> changed since v1:
> * Addressed all the Review comments.
> * Minor code rebasing.
> 
> Pradeep P V K (2):
>   dt-bindings: mmc: sdhci-msm: Add Bus BW vote supported strings
>   mmc: sdhci-msm: Add support for bus bandwidth voting
> 
>  .../devicetree/bindings/mmc/sdhci-msm.txt          |  32 ++
>  drivers/mmc/host/sdhci-msm.c                       | 366 ++++++++++++++++++++-
>  2 files changed, 395 insertions(+), 3 deletions(-)
> 
> -- 
> 1.9.1
> 



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux