From: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
With the introduction of SSR support in the ADSP PIL we should describe
the SMD edge inside the ADSP PIL node.
Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
[luca@xxxxxxxxx: Add label for the smd edge]
Signed-off-by: Luca Weiss <luca@xxxxxxxxx>
---
arch/arm/boot/dts/qcom-msm8974.dtsi | 16 +++++++++-------
1 file changed, 9 insertions(+), 7 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-msm8974.dtsi b/arch/arm/boot/dts/qcom-msm8974.dtsi
index b357cb51c0fb..9c8089e26a60 100644
--- a/arch/arm/boot/dts/qcom-msm8974.dtsi
+++ b/arch/arm/boot/dts/qcom-msm8974.dtsi
@@ -360,6 +360,15 @@ adsp-pil {
qcom,smem-states = <&adsp_smp2p_out 0>;
qcom,smem-state-names = "stop";
+
+ smd-edge {
+ interrupts = <GIC_SPI 156 IRQ_TYPE_EDGE_RISING>;
+
+ qcom,ipc = <&apcs 8 8>;
+ qcom,smd-edge = <1>;
+
+ label = "lpass";
+ };
};
smem {
@@ -1569,13 +1578,6 @@ reboot-mode {
smd {
compatible = "qcom,smd";
- adsp {
- interrupts = <GIC_SPI 156 IRQ_TYPE_EDGE_RISING>;
-
- qcom,ipc = <&apcs 8 8>;
- qcom,smd-edge = <1>;
- };
-
rpm {
interrupts = <GIC_SPI 168 IRQ_TYPE_EDGE_RISING>;
qcom,ipc = <&apcs 8 0>;
--
2.24.0
