On 14-08-19, 10:03, Stephen Boyd wrote:
> Quoting Vinod Koul (2019-08-14 05:49:56)
> > Add base DTS file for pm8150 along with GPIOs
> >
> > Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> > ---
> > arch/arm64/boot/dts/qcom/pm8150.dtsi | 41 ++++++++++++++++++++++++++++
> > 1 file changed, 41 insertions(+)
> > create mode 100644 arch/arm64/boot/dts/qcom/pm8150.dtsi
> >
> > diff --git a/arch/arm64/boot/dts/qcom/pm8150.dtsi b/arch/arm64/boot/dts/qcom/pm8150.dtsi
> > new file mode 100644
> > index 000000000000..b533e254a203
> > --- /dev/null
> > +++ b/arch/arm64/boot/dts/qcom/pm8150.dtsi
> > @@ -0,0 +1,41 @@
> > +// SPDX-License-Identifier: BSD-3-Clause
> > +// Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
> > +// Copyright (c) 2019, Linaro Limited
> > +
> > +#include <dt-bindings/interrupt-controller/irq.h>
> > +#include <dt-bindings/spmi/spmi.h>
> > +
> > +&spmi_bus {
> > + pm8150_0: pm8150@0 {
>
> I think node name should be 'pmic'
Yes will fix.
>
> > + compatible = "qcom,spmi-pmic";
>
> This should also have the model number? "qcom,pm8150"?
Added now
> > + reg = <0x0 SPMI_USID>;
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > +
> > + pm8150_gpios: gpio@c000 {
> > + compatible = "qcom,pm8150-gpio";
> > + reg = <0xc000>;
> > + gpio-controller;
> > + #gpio-cells = <2>;
> > + interrupts = <0 0xc0 0 IRQ_TYPE_NONE>,
> > + <0 0xc1 0 IRQ_TYPE_NONE>,
> > + <0 0xc2 0 IRQ_TYPE_NONE>,
> > + <0 0xc3 0 IRQ_TYPE_NONE>,
> > + <0 0xc4 0 IRQ_TYPE_NONE>,
> > + <0 0xc5 0 IRQ_TYPE_NONE>,
> > + <0 0xc6 0 IRQ_TYPE_NONE>,
> > + <0 0xc7 0 IRQ_TYPE_NONE>,
> > + <0 0xc8 0 IRQ_TYPE_NONE>,
> > + <0 0xc9 0 IRQ_TYPE_NONE>,
> > + <0 0xca 0 IRQ_TYPE_NONE>,
> > + <0 0xcb 0 IRQ_TYPE_NONE>;
> > + };
> > + };
> > +
> > + qcom,pm8150@1 {
>
> Same comment, pmic@1.
right, here and everywhere else
--
~Vinod
