On 05-06-19, 21:38, Bjorn Andersson wrote:
> This adds an initial dts for the Dragonboard 845. Supported
> functionality includes Debug UART, UFS, USB-C (peripheral), USB-A
> (host), microSD-card and Bluetooth.
>
> Initializing the SMMU is clearing the mapping used for the splash screen
> framebuffer, which causes the board to reboot. This can be worked around
> using:
>
> fastboot oem select-display-panel none
I was able to boot db845c on v5.2-rc1 with this patch :)
I found some nits, nevertheless this looks good, so:
Tested-by: Vinod Koul <vkoul@xxxxxxxxxx>
Reviewed-by: Vinod Koul <vkoul@xxxxxxxxxx>
> +++ b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts
> @@ -0,0 +1,556 @@
> +// SPDX-License-Identifier: GPL-2.0
No copyright?
> + pcie0_3p3v_dual: vldo-3v3-regulator {
> + compatible = "regulator-fixed";
> + regulator-name = "VLDO_3V3";
> +
> + vin-supply = <&vbat>;
> + regulator-min-microvolt = <3300000>;
> + regulator-max-microvolt = <3300000>;
> +
> + gpio = <&tlmm 90 GPIO_ACTIVE_HIGH>;
> + enable-active-high;
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&pcie0_pwren_state>;
> + };
> +
> + gpio_keys {
Rest of this file is sorted but this isn't, so this should be after dc12v
> + compatible = "gpio-keys";
> + #address-cells = <1>;
does this require address cell, we don't have range property here?
> + #size-cells = <0>;
> + autorepeat;
> +
> + pinctrl-names = "default";
> + pinctrl-0 = <&vol_up_pin_a>;
> +
> + vol-up {
> + label = "Volume Up";
> + linux,code = <KEY_VOLUMEUP>;
> + gpios = <&pm8998_gpio 6 GPIO_ACTIVE_LOW>;
> + };
> + };
> +
> + leds {
This one as well..
--
~Vinod
