Re: [PATCH v6 10/10] soc: qcom: rpmhpd: Mark mx as a parent for cx

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




[]...

This is used to enforce a requirement that exists for various
hardware blocks on SDM845 that MX performance state >= CX performance
state for a given operating frequency.

I assume that also means the MX power domain must not be power off as
long as the CX power domain is powered on?

So with rpmh, there's really no separate on/off control, we just put
it in the lowest perf state at off.

I think in theory the answer is MX can't be off if CX is on, but in
reality, MX and CX are never turned off, just set to something really
low and even then the constraint applies for MX >= CX. Is that right?

to some extent, let me clarify this a bit more. rpmh is the central entity
controlling these rails and takes a final call on when it can or cannot
be 'really' off and when its turned on, at what level it should be set to.

CPU is just one of the entities 'voting' on them. Now legacy platforms which
had rpm (like msm8996) did have separate control to send a
on/off vote and a performance level vote. With rpmh, its just that there
is no separate message that you send to rpmh for OFF, its just mapped to
the lowest perf level. So think of it as the lowest perf level is mapped to
a '0' which is same as OFF.

So when you say 'MX can't be off if CX is on', yes MX can't be at the lowest
level '0', while CX is at something higher.

Just to make sure there are no conflicting hierarchical constraints
between idle management and performance state management!?


I'm not sure what idle states mean to the CX and MX domains. Would it be
some sort of idle state governor attached at genpd creation time that
would adjust the main SoC power rails when all devices attached are
idle? Maybe I don't understand how idle states are different from
performance states.
My understanding is that devices using these domains would almost always
expect their clk frequency and clk on/off state to decide what the
performance state is, unless they need to ignore clk state because they
aren't managing clks and bump up the voltage directly when the device is
active. Either way, devices are actively managing the voltage they need
these voltage domains to operate at by using the genpd performance
states APIs.

I am not quite sure whats the point that you are trying to make here,
but this is what I would expect the users of these genpds to do,
regardless of if they have a clk dependency or not.
When the device is active, vote for a performance state they need
then request for the genpd to be on. When they are idle, request for the
genpd to be turned off.


[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux