For all 96Boards, the following standard is used for onboard LEDs.
green:user1 default-trigger: heartbeat
green:user2 default-trigger: mmc0/disk-activity(onboard-storage)
green:user3 default-trigger: mmc1 (SD-card)
green:user4 default-trigger: none, panic-indicator
yellow:wlan default-trigger: phy0tx
blue:bt default-trigger: hci0-power
So lets adopt the same for Poplar, which is one of the 96Boards
Enterprise edition platform.
Due to absence of WLAN and BT support, corresponding LED nodes are not
considered.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
.../arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts | 13 +++++++------
1 file changed, 7 insertions(+), 6 deletions(-)
diff --git a/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts b/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
index d30f6eb8a5ee..32716c96b457 100644
--- a/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
+++ b/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
@@ -35,30 +35,31 @@
compatible = "gpio-leds";
user-led0 {
- label = "USER-LED0";
+ label = "green:user1";
gpios = <&gpio6 3 GPIO_ACTIVE_LOW>;
linux,default-trigger = "heartbeat";
default-state = "off";
};
user-led1 {
- label = "USER-LED1";
+ label = "green:user2";
gpios = <&gpio5 1 GPIO_ACTIVE_LOW>;
linux,default-trigger = "mmc0";
default-state = "off";
};
user-led2 {
- label = "USER-LED2";
+ label = "green:user3";
gpios = <&gpio5 2 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "none";
+ linux,default-trigger = "mmc1";
default-state = "off";
};
user-led3 {
- label = "USER-LED3";
+ label = "green:user4";
gpios = <&gpio10 6 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "cpu0";
+ linux,default-trigger = "none";
+ panic-indicator;
default-state = "off";
};
};
--
2.17.1
