This series updates the device tree bindings for the QMP PHY to properly specify the registers for dual-lane PHYs. It then updates the driver to use those new registers. Then it adds the DT nodes for UFS on SDM845, and activates them on the MTP platform. Finally, it fixes up the USB3 PHY on SDM845, which is also a dual lane PHY. The DT binding change is needed because it was discovered that the UFS PHY driver was reaching beyond its register region, which only happened to work by virtue of the page size granularity. Changes since v1: - Added dt bindings change, corresponding driver fixup, and USB PHY fixup - Renamed ufsphy to phy (Vivek). - Removed #clock-cells (Vivek). This applies atop linux-next 20181018 with the addition of Doug's changes [1] and [2]. [1] https://lore.kernel.org/lkml/20181012213632.252346-1-dianders@xxxxxxxxxxxx/ [2] https://lore.kernel.org/lkml/20181012213926.253765-1-dianders@xxxxxxxxxxxx/ Can Guo (1): arm64: dts: qcom: sdm845: Add UFS nodes for sdm845-mtp Evan Green (4): dt-bindings: phy-qcom-qmp: Fix register underspecification phy: qcom-qmp: Utilize fully-specified DT registers arm64: dts: qcom: sdm845: add UFS controller arm64: dts: qcom: sdm845: Add USB PHY lane two .../devicetree/bindings/phy/qcom-qmp-phy.txt | 73 ++++++++++++++++++--- arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 14 ++++ arch/arm64/boot/dts/qcom/sdm845.dtsi | 75 +++++++++++++++++++++- drivers/phy/qualcomm/phy-qcom-qmp.c | 51 +++++++++++---- 4 files changed, 190 insertions(+), 23 deletions(-) -- 2.16.4
