Re: [PATCH RESEND v1 2/5] drivers: pinctrl: msm: enable PDC interrupt only during suspend

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Aug 27 2018 at 14:01 -0600, Stephen Boyd wrote:
Quoting Lina Iyer (2018-08-24 10:14:32)
On Fri, Aug 24 2018 at 02:22 -0600, Stephen Boyd wrote:
>Quoting Lina Iyer (2018-08-17 12:10:23)
>> During suspend the system may power down some of the system rails. As a
>> result, the TLMM hw block may not be operational anymore and wakeup
>> capable GPIOs will not be detected. The PDC however will be operational
>> and the GPIOs that are routed to the PDC as IRQs can wake the system up.
>>
>> To avoid being interrupted twice (for TLMM and once for PDC IRQ) when a
>> GPIO trips, use TLMM for active and switch to PDC for suspend. When
>> entering suspend, disable the TLMM wakeup interrupt and instead enable
>> the PDC IRQ and revert upon resume.
>
>What about idle paths? Don't we want to disable the TLMM interrupt and
>enable the PDC interrupt when the whole cluster goes idle so we get
>wakeup interrupts?
We would need to do this from the idle paths. When we have that support
(a patch for cluster power down is in the works), we would need to hook
up to TLMM and do the same.

Ok so then this approach doesn't really seem to work for the CPU idle
paths.

>Because of this complicated dance, it may make sense to always get the
>interrupt at the PDC and then replay it into the TLMM chip "manually"
>with the irq_set_irqchip_state() APIs. This way the duplicate interrupt
>can't happen. The only way for the interrupt handler to run would be by
>PDC poking the TLMM hardware to inject the irq into the status register.
If the PDC interrupt was always enabled and the interrupt at TLMM was
always disabled, all we would need to set the action handler of the PDC
interrupt to that of the TLMM. I couldn't find a way to retrieve that
nicely.

Can't we just configure a different chained IRQ handler with
irq_set_chained_handler_and_data() for each of the GPIO IRQs that are
handled by PDC to be the interrupts provide by the PDC irq controller
that match the GPIOs? And then set their parent irq with
irq_set_parent() for completeness? And also move those GPIOs from the
existing msm_gpio irqchip to a different PDC gpio irqchip that does
nothing besides push irqchip calls up to the PDC irqchip? Then we don't
even have to think about resending anything and we can rely on PDC to do
all the interrupt sensing all the time but still provide the irqs from
the GPIO controller.

Seems like the irqchips need to be in hierarchy for this to work, which
is not the case with TLMM and the PDC, currently.

-- Lina




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux