On Thu, Aug 09, 2018 at 06:02:39PM +0530, Amit Kucheria wrote:
> The SROT registers are initialised by the secure firmware at boot. We
> don't have write access to the registers. Check if the block is enabled
> before continuing.
>
> Signed-off-by: Amit Kucheria <amit.kucheria@xxxxxxxxxx>
> ---
> drivers/thermal/qcom/tsens-common.c | 17 +++++++++++++++++
> 1 file changed, 17 insertions(+)
>
> diff --git a/drivers/thermal/qcom/tsens-common.c b/drivers/thermal/qcom/tsens-common.c
> index 0b8a793f15f4..d250b757d1f0 100644
> --- a/drivers/thermal/qcom/tsens-common.c
> +++ b/drivers/thermal/qcom/tsens-common.c
> @@ -12,6 +12,11 @@
> #include <linux/regmap.h>
> #include "tsens.h"
>
> +/* SROT */
> +#define CTRL_OFFSET 0x4
> +#define TSENS_EN BIT(0)
> +
> +/* TM */
> #define STATUS_OFFSET 0x30
> #define SN_ADDR_OFFSET 0x4
> #define SN_ST_TEMP_MASK 0x3ff
> @@ -119,6 +124,8 @@ int __init init_common(struct tsens_device *tmdev)
> {
> void __iomem *tm_base, *srot_base;
> struct resource *res;
> + u32 code;
> + int ret;
> struct platform_device *op = of_find_device_by_node(tmdev->dev->of_node);
>
> if (!op)
> @@ -151,5 +158,15 @@ int __init init_common(struct tsens_device *tmdev)
> if (IS_ERR(tmdev->tm_map))
> return PTR_ERR(tmdev->tm_map);
>
> + if (tmdev->srot_map) {
> + ret = regmap_read(tmdev->srot_map, CTRL_OFFSET, &code);
> + if (ret)
> + return ret;
> + if (!(code & TSENS_EN)) {
> + dev_err(tmdev->dev, "tsens device is not enabled\n");
> + return -ENODEV;
> + }
> + }
> +
> return 0;
> }
Reviewed-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
