The SROT registers are initialised by the secure firmware at boot. We
don't have write access to the registers. Check if the block is enabled
before continuing.
Signed-off-by: Amit Kucheria <amit.kucheria@xxxxxxxxxx>
---
drivers/thermal/qcom/tsens-common.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)
diff --git a/drivers/thermal/qcom/tsens-common.c b/drivers/thermal/qcom/tsens-common.c
index 0b8a793f15f4..d250b757d1f0 100644
--- a/drivers/thermal/qcom/tsens-common.c
+++ b/drivers/thermal/qcom/tsens-common.c
@@ -12,6 +12,11 @@
#include <linux/regmap.h>
#include "tsens.h"
+/* SROT */
+#define CTRL_OFFSET 0x4
+#define TSENS_EN BIT(0)
+
+/* TM */
#define STATUS_OFFSET 0x30
#define SN_ADDR_OFFSET 0x4
#define SN_ST_TEMP_MASK 0x3ff
@@ -119,6 +124,8 @@ int __init init_common(struct tsens_device *tmdev)
{
void __iomem *tm_base, *srot_base;
struct resource *res;
+ u32 code;
+ int ret;
struct platform_device *op = of_find_device_by_node(tmdev->dev->of_node);
if (!op)
@@ -151,5 +158,15 @@ int __init init_common(struct tsens_device *tmdev)
if (IS_ERR(tmdev->tm_map))
return PTR_ERR(tmdev->tm_map);
+ if (tmdev->srot_map) {
+ ret = regmap_read(tmdev->srot_map, CTRL_OFFSET, &code);
+ if (ret)
+ return ret;
+ if (!(code & TSENS_EN)) {
+ dev_err(tmdev->dev, "tsens device is not enabled\n");
+ return -ENODEV;
+ }
+ }
+
return 0;
}
--
2.17.1
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
