On 21.06.2018 14:32, Sandeep Panda wrote: > Innolux TV123WAM is a 12.3" eDP display panel with > 2160x1440 resolution, which can be supported by simple > panel driver. Are you sure this is Innolux? Quick grep on Internet finds only BOE panel with this TV123WAM[1]. [1]: https://e2e.ti.com/cfs-file/__key/communityserver-discussions-components-files/138/TV123WAM_2D00_ND0_5F00_Product-spec_5F00_BOE_5F00_20161115_2D00_A00.pdf Regards Andrzej > > Changes in v1: > - Make use of simple panel driver instead of creating > a new driver for this panel (Sean Paul). > - Combine dt-binding and driver changes into one patch > as done by other existing panel support changes. > > Changes in v2: > - Separate driver change from dt-binding documentation (Rob Herring). > - Add the properties from simple-panel binding that are applicable to > this panel (Rob Herring). > > Signed-off-by: Sandeep Panda <spanda@xxxxxxxxxxxxxx> > Reviewed-by: Rob Herring <robh@xxxxxxxxxx> > --- > .../bindings/display/panel/innolux,tv123wam.txt | 20 ++++++++++++++++++++ > 1 file changed, 20 insertions(+) > create mode 100644 Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt > > diff --git a/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt b/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt > new file mode 100644 > index 000000000000..a9b35265fa13 > --- /dev/null > +++ b/Documentation/devicetree/bindings/display/panel/innolux,tv123wam.txt > @@ -0,0 +1,20 @@ > +Innolux TV123WAM 12.3 inch eDP 2K display panel > + > +This binding is compatible with the simple-panel binding, which is specified > +in simple-panel.txt in this directory. > + > +Required properties: > +- compatible: should be "innolux,tv123wam" > +- power-supply: regulator to provide the supply voltage > + > +Optional properties: > +- enable-gpios: GPIO pin to enable or disable the panel > +- backlight: phandle of the backlight device attached to the panel > + > +Example: > + panel_edp: panel-edp { > + compatible = "innolux,tv123wam"; > + enable-gpios = <&msmgpio 31 GPIO_ACTIVE_LOW>; > + power-supply = <&pm8916_l2>; > + backlight = <&backlight>; > + }; -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
