Hi,
On Thu, Jun 28, 2018 at 2:09 PM, Matthias Kaehlcke <mka@xxxxxxxxxxxx> wrote:
> Add pm8998 thermal zone based on the examples in the spmi-temp-alarm
> bindings.
>
> Note: devices with the pm8998 need to have a 'thermal-zones' node (which
> may be empty) with a label 'thermal_zones'.
>
> Signed-off-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/pm8998.dtsi | 28 ++++++++++++++++++++++++++++
> 1 file changed, 28 insertions(+)
Do you know if this patch actually does anything since you didn't
define a cooling-maps? Hopefully at least the critical shuts things
down?
Do you have any idea how we'll eventually want to specify a
cooling-maps? Are we just going to assume we're included by an sdm845
device and refer to the big/little CPU phandles?
> diff --git a/arch/arm64/boot/dts/qcom/pm8998.dtsi b/arch/arm64/boot/dts/qcom/pm8998.dtsi
> index f2d39074ed74..d85ceb4f976b 100644
> --- a/arch/arm64/boot/dts/qcom/pm8998.dtsi
> +++ b/arch/arm64/boot/dts/qcom/pm8998.dtsi
> @@ -3,6 +3,7 @@
>
> #include <dt-bindings/spmi/spmi.h>
> #include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/thermal/thermal.h>
>
> &spmi_bus {
> pm8998_lsid0: pmic@0 {
> @@ -59,3 +60,30 @@
> #size-cells = <0>;
> };
> };
> +
> +&thermal_zones {
As per comments in patch #1, don't rely on a label. Just put your
stuff in a top-level "thermal-zones" node.
> + pm8998 {
> + polling-delay-passive = <250>;
> + polling-delay = <1000>;
> +
> + thermal-sensors = <&pm8998_temp>;
> +
> + trips {
> + passive {
IMO you should proactively put a label on these trips even if there's
no cooling device yet. It's expected that at some point someone will
add a cooling device and refer to them, right?
-Doug
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
