Add a module parameter to override SCL frequency provided by firmware.
This can be useful when testing spec compliance for I2C modes or when
debugging issues across multiple operating frequencies.
Signed-off-by: Austin Christ <austinwc@xxxxxxxxxxxxxx>
Reviewed-by: Sricharan R <sricharan@xxxxxxxxxxxxxx>
---
v1:
- Initial
v2:
- No changes
v3:
- No changes
---
drivers/i2c/busses/i2c-qup.c | 19 ++++++++++++++-----
1 file changed, 14 insertions(+), 5 deletions(-)
diff --git a/drivers/i2c/busses/i2c-qup.c b/drivers/i2c/busses/i2c-qup.c
index f87f29f..da4cc57 100644
--- a/drivers/i2c/busses/i2c-qup.c
+++ b/drivers/i2c/busses/i2c-qup.c
@@ -155,6 +155,10 @@
/* TAG length for DATA READ in RX FIFO */
#define READ_RX_TAGS_LEN 2
+static unsigned int scl_freq;
+module_param_named(scl_freq, scl_freq, uint, 0444);
+MODULE_PARM_DESC(scl_freq, "SCL frequency override");
+
/*
* count: no of blocks
* pos: current block number
@@ -1682,11 +1686,16 @@ static int qup_i2c_probe(struct platform_device *pdev)
init_completion(&qup->xfer);
platform_set_drvdata(pdev, qup);
- ret = device_property_read_u32(qup->dev, "clock-frequency", &clk_freq);
- if (ret) {
- dev_notice(qup->dev, "using default clock-frequency %d",
- DEFAULT_CLK_FREQ);
- }
+ if (scl_freq) {
+ dev_notice(qup->dev, "Using override frequency of %u\n", scl_freq);
+ clk_freq = scl_freq;
+ } else {
+ ret = device_property_read_u32(qup->dev, "clock-frequency", &clk_freq);
+ if (ret) {
+ dev_notice(qup->dev, "using default clock-frequency %d",
+ DEFAULT_CLK_FREQ);
+ }
+ }
if (of_device_is_compatible(pdev->dev.of_node, "qcom,i2c-qup-v1.1.1")) {
qup->adap.algo = &qup_i2c_algo;
--
Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
