On Wed, 19 Jul 2017 17:17:55 +0530
Abhishek Sahu <absahu@xxxxxxxxxxxxxx> wrote:
> Each NAND page consist of multiple codewords. Following is
> sequence for NAND page read according to hardware guide.
>
> 1. Program Power-up configuration, page row, page column
> address and flash configuration registers.
> 2. Write NAND_FLASH_CMD followed by NANC_EXEC_CMD for each
> codeword.
> 3. Read NAND_FLASH_STATUS for each codeword.
>
> The step 1 should be done once for each page and step 2,3 should
> be done for each codeword.
>
> Currently, all the 3 steps are being done for each codeword which
> is wrong. Now this patch reorganizes read page functions to
> configure page specific register once and per codeword specific
> registers for each NAND ECC step.
Applied.
Thanks,
Boris
>
> Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
> ---
> drivers/mtd/nand/qcom_nandc.c | 37 +++++++++++++++++++++++++++----------
> 1 file changed, 27 insertions(+), 10 deletions(-)
>
> diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
> index 110a26a..27ea594 100644
> --- a/drivers/mtd/nand/qcom_nandc.c
> +++ b/drivers/mtd/nand/qcom_nandc.c
> @@ -605,15 +605,23 @@ static int write_data_dma(struct qcom_nand_controller *nandc, int reg_off,
> }
>
> /*
> - * helper to prepare dma descriptors to configure registers needed for reading a
> - * codeword/step in a page
> + * Helper to prepare DMA descriptors for configuring registers
> + * before reading a NAND page.
> */
> -static void config_cw_read(struct qcom_nand_controller *nandc)
> +static void config_nand_page_read(struct qcom_nand_controller *nandc)
> {
> - write_reg_dma(nandc, NAND_FLASH_CMD, 3);
> + write_reg_dma(nandc, NAND_ADDR0, 2);
> write_reg_dma(nandc, NAND_DEV0_CFG0, 3);
> write_reg_dma(nandc, NAND_EBI2_ECC_BUF_CFG, 1);
> +}
>
> +/*
> + * Helper to prepare DMA descriptors for configuring registers
> + * before reading each codeword in NAND page.
> + */
> +static void config_nand_cw_read(struct qcom_nand_controller *nandc)
> +{
> + write_reg_dma(nandc, NAND_FLASH_CMD, 1);
> write_reg_dma(nandc, NAND_EXEC_CMD, 1);
>
> read_reg_dma(nandc, NAND_FLASH_STATUS, 2);
> @@ -621,9 +629,15 @@ static void config_cw_read(struct qcom_nand_controller *nandc)
> }
>
> /*
> - * helpers to prepare dma descriptors used to configure registers needed for
> - * writing a codeword/step in a page
> + * Helper to prepare dma descriptors to configure registers needed for reading a
> + * single codeword in page
> */
> +static void config_nand_single_cw_page_read(struct qcom_nand_controller *nandc)
> +{
> + config_nand_page_read(nandc);
> + config_nand_cw_read(nandc);
> +}
> +
> static void config_cw_write_pre(struct qcom_nand_controller *nandc)
> {
> write_reg_dma(nandc, NAND_FLASH_CMD, 3);
> @@ -692,7 +706,7 @@ static int nandc_param(struct qcom_nand_host *host)
> nandc->buf_count = 512;
> memset(nandc->data_buffer, 0xff, nandc->buf_count);
>
> - config_cw_read(nandc);
> + config_nand_single_cw_page_read(nandc);
>
> read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer,
> nandc->buf_count);
> @@ -1105,6 +1119,8 @@ static int read_page_ecc(struct qcom_nand_host *host, u8 *data_buf,
> struct nand_ecc_ctrl *ecc = &chip->ecc;
> int i, ret;
>
> + config_nand_page_read(nandc);
> +
> /* queue cmd descs for each codeword */
> for (i = 0; i < ecc->steps; i++) {
> int data_size, oob_size;
> @@ -1118,7 +1134,7 @@ static int read_page_ecc(struct qcom_nand_host *host, u8 *data_buf,
> oob_size = host->ecc_bytes_hw + host->spare_bytes;
> }
>
> - config_cw_read(nandc);
> + config_nand_cw_read(nandc);
>
> if (data_buf)
> read_data_dma(nandc, FLASH_BUF_ACC, data_buf,
> @@ -1178,7 +1194,7 @@ static int copy_last_cw(struct qcom_nand_host *host, int page)
> set_address(host, host->cw_size * (ecc->steps - 1), page);
> update_rw_regs(host, 1, true);
>
> - config_cw_read(nandc);
> + config_nand_single_cw_page_read(nandc);
>
> read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer, size);
>
> @@ -1228,6 +1244,7 @@ static int qcom_nandc_read_page_raw(struct mtd_info *mtd,
>
> host->use_ecc = false;
> update_rw_regs(host, ecc->steps, true);
> + config_nand_page_read(nandc);
>
> for (i = 0; i < ecc->steps; i++) {
> int data_size1, data_size2, oob_size1, oob_size2;
> @@ -1246,7 +1263,7 @@ static int qcom_nandc_read_page_raw(struct mtd_info *mtd,
> oob_size2 = host->ecc_bytes_hw + host->spare_bytes;
> }
>
> - config_cw_read(nandc);
> + config_nand_cw_read(nandc);
>
> read_data_dma(nandc, reg_off, data_buf, data_size1);
> reg_off += data_size1;
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
