On 2017-08-03 21:17, Boris Brezillon wrote:
On Wed, 19 Jul 2017 17:17:50 +0530
Abhishek Sahu <absahu@xxxxxxxxxxxxxx> wrote:
The current driver is failing without complete bootchain since
NAND_DEV_CMD_VLD value is not valid.
Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
---
drivers/mtd/nand/qcom_nandc.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/mtd/nand/qcom_nandc.c
b/drivers/mtd/nand/qcom_nandc.c
index bc0408c..f3b995d 100644
--- a/drivers/mtd/nand/qcom_nandc.c
+++ b/drivers/mtd/nand/qcom_nandc.c
@@ -148,6 +148,9 @@
#define FETCH_ID 0xb
#define RESET_DEVICE 0xd
+/* Value for NAND_DEV_CMD_VLD */
+#define NAND_DEV_CMD_VLD_VAL 0x1d
Where does this 0x1d value comes from? Defining a macro instead of
passing 0x1d does not change the fact that this is a magic value :-).
This register tells the NAND controller which commands are valid
Bits Meaning
0 READ_START_VALID
1 READ_STOP_VALID
2 WRITE_START_VALID
3 ERASE_START_VALID
4 SEQ_READ_START_VLD
The default power on value is
0xe - ERASE_START_VALID | WRITE_START_VALID | READ_STOP_VALID
It need to be programmed for
0x1d - READ_START_VALID | WRITE_START_VALID | ERASE_START_VALID |
SEQ_READ_START_VLD
Read STOP command is not required in normal NAND reads so it need to be
disabled.
I will define the individual bits and will make this value with bits
which will
make this more clear.
+
/*
* the NAND controller performs reads/writes with ECC in 516 byte
chunks.
* the driver calls the chunks 'step' or 'codeword' interchangeably
@@ -1972,6 +1975,7 @@ static int qcom_nandc_setup(struct
qcom_nand_controller *nandc)
{
/* kill onenand */
nandc_write(nandc, SFLASHC_BURST_CFG, 0);
+ nandc_write(nandc, NAND_DEV_CMD_VLD, NAND_DEV_CMD_VLD_VAL);
/* enable ADM DMA */
nandc_write(nandc, NAND_FLASH_CHIP_SELECT, DM_EN);
--
Abhishek Sahu
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
