[RESEND PATCH v4 4/7] remoteproc: qcom: Modify clock enable and disable routine

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Clock handling is made generic than earlier way to add new clock
every time when required to support new hexagon version. Also
clock disable interface is separated out into two separate routine
to unvote proxy clock alone when handover interrupt is arrived.

Signed-off-by: Avaneesh Kumar Dwivedi <akdwived@xxxxxxxxxxxxxx>
---
 drivers/remoteproc/qcom_q6v5_pil.c | 93 ++++++++++++++++++++++++++------------
 1 file changed, 65 insertions(+), 28 deletions(-)

diff --git a/drivers/remoteproc/qcom_q6v5_pil.c b/drivers/remoteproc/qcom_q6v5_pil.c
index 06d5bb2..c55dc9a 100644
--- a/drivers/remoteproc/qcom_q6v5_pil.c
+++ b/drivers/remoteproc/qcom_q6v5_pil.c
@@ -126,10 +126,6 @@ struct q6v5 {
 	struct qcom_smem_state *state;
 	unsigned stop_bit;
 
-
-	struct clk *ahb_clk;
-	struct clk *axi_clk;
-	struct clk *rom_clk;
 	struct clk *active_clks[8];
 	struct clk *proxy_clks[4];
 	struct reg_info active_regs[1];
@@ -284,6 +280,51 @@ static void q6v5_regulator_disable(struct q6v5 *qproc)
 	q6v5_active_regulator_disable(qproc);
 }
 
+static int q6v5_clk_enable(struct device *dev, struct clk **clks,
+								int clk_count)
+{
+	int rc = 0;
+	int i;
+
+	for (i = 0; i < clk_count; i++) {
+		rc = clk_prepare_enable(clks[i]);
+		if (rc) {
+			dev_err(dev, "Clock enable failed\n");
+			goto err;
+		}
+	}
+
+	return 0;
+err:
+	for (i--; i >= 0; i--)
+		clk_disable_unprepare(clks[i]);
+
+	return rc;
+}
+
+static void q6v5_proxy_clk_disable(struct q6v5 *qproc)
+{
+	int i;
+	struct clk **clks = qproc->proxy_clks;
+
+	for (i = 0; i < qproc->proxy_clk_count; i++)
+		clk_disable_unprepare(clks[i]);
+}
+
+static void q6v5_active_clk_disable(struct q6v5 *qproc)
+{
+	int i;
+	struct clk **clks = qproc->proxy_clks;
+
+	for (i = 0; i < qproc->proxy_clk_count; i++)
+		clk_disable_unprepare(clks[i]);
+}
+
+static void q6v5_clk_disable(struct q6v5 *qproc)
+{
+	q6v5_proxy_clk_disable(qproc);
+	q6v5_active_clk_disable(qproc);
+}
 
 static int q6v5_load(struct rproc *rproc, const struct firmware *fw)
 {
@@ -581,11 +622,18 @@ static int q6v5_start(struct rproc *rproc)
 		return ret;
 	}
 
+	ret = q6v5_clk_enable(qproc->dev, qproc->proxy_clks,
+		qproc->proxy_clk_count);
+	if (ret) {
+		dev_err(qproc->dev, "failed to enable proxy clocks\n");
+		goto disable_proxy_reg;
+	}
+
 	ret = q6v5_regulator_enable(qproc, qproc->active_regs,
 		qproc->active_reg_count);
 	if (ret) {
 		dev_err(qproc->dev, "failed to enable supplies\n");
-		goto disable_proxy_reg;
+		goto disable_proxy_clk;
 	}
 	ret = reset_control_deassert(qproc->mss_restart);
 	if (ret) {
@@ -593,17 +641,12 @@ static int q6v5_start(struct rproc *rproc)
 		goto disable_vdd;
 	}
 
-	ret = clk_prepare_enable(qproc->ahb_clk);
-	if (ret)
+	ret = q6v5_clk_enable(qproc->dev, qproc->active_clks,
+		qproc->active_clk_count);
+	if (ret) {
+		dev_err(qproc->dev, "failed to enable clocks\n");
 		goto assert_reset;
-
-	ret = clk_prepare_enable(qproc->axi_clk);
-	if (ret)
-		goto disable_ahb_clk;
-
-	ret = clk_prepare_enable(qproc->rom_clk);
-	if (ret)
-		goto disable_axi_clk;
+	}
 
 	writel(qproc->mba_phys, qproc->rmb_base + RMB_MBA_IMAGE_REG);
 
@@ -638,25 +681,21 @@ static int q6v5_start(struct rproc *rproc)
 
 	qproc->running = true;
 
-	/* TODO: All done, release the handover resources */
-
+	q6v5_proxy_clk_disable(qproc);
+	q6v5_proxy_regulator_disable(qproc);
 	return 0;
 
 halt_axi_ports:
 	q6v5proc_halt_axi_port(qproc, qproc->halt_map, qproc->halt_q6);
 	q6v5proc_halt_axi_port(qproc, qproc->halt_map, qproc->halt_modem);
 	q6v5proc_halt_axi_port(qproc, qproc->halt_map, qproc->halt_nc);
-
-	clk_disable_unprepare(qproc->rom_clk);
-disable_axi_clk:
-	clk_disable_unprepare(qproc->axi_clk);
-disable_ahb_clk:
-	clk_disable_unprepare(qproc->ahb_clk);
+	q6v5_active_clk_disable(qproc);
 assert_reset:
 	reset_control_assert(qproc->mss_restart);
 disable_vdd:
-	q6v5_regulator_disable(qproc);
-
+	q6v5_active_regulator_disable(qproc);
+disable_proxy_clk:
+	q6v5_proxy_clk_disable(qproc);
 disable_proxy_reg:
 	q6v5_proxy_regulator_disable(qproc);
 	return ret;
@@ -684,9 +723,7 @@ static int q6v5_stop(struct rproc *rproc)
 	q6v5proc_halt_axi_port(qproc, qproc->halt_map, qproc->halt_nc);
 
 	reset_control_assert(qproc->mss_restart);
-	clk_disable_unprepare(qproc->rom_clk);
-	clk_disable_unprepare(qproc->axi_clk);
-	clk_disable_unprepare(qproc->ahb_clk);
+	q6v5_clk_disable(qproc);
 	q6v5_regulator_disable(qproc);
 
 	return 0;
-- 
Qualcomm India Private Limited, on behalf of Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project.

--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux