On 11/07, Ritesh Harjani wrote:
>
> diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
> index 42f42aa..32b0b79 100644
> --- a/drivers/mmc/host/sdhci-msm.c
> +++ b/drivers/mmc/host/sdhci-msm.c
> @@ -58,11 +58,17 @@
> #define CORE_DLL_CONFIG 0x100
> #define CORE_DLL_STATUS 0x108
>
> +#define CORE_DLL_CONFIG_2 0x1b4
> +#define CORE_FLL_CYCLE_CNT BIT(18)
> +#define CORE_DLL_CLOCK_DISABLE BIT(21)
> +
> #define CORE_VENDOR_SPEC 0x10c
> #define CORE_CLK_PWRSAVE BIT(1)
>
> #define CORE_VENDOR_SPEC_CAPABILITIES0 0x11c
>
> +#define TCXO_FREQ 19200000
TCXO_FREQ could change based on the board. For example, IPQ has
it as 25 MHz.
> +
> #define CDR_SELEXT_SHIFT 20
> #define CDR_SELEXT_MASK (0xf << CDR_SELEXT_SHIFT)
> #define CMUX_SHIFT_PHASE_SHIFT 24
> @@ -330,6 +349,24 @@ static int msm_init_cm_dll(struct sdhci_host *host)
> writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
> msm_cm_dll_set_freq(host);
>
> + if (msm_host->use_14lpp_dll_reset) {
> + u32 mclk_freq = 0;
> +
> + if ((readl_relaxed(host->ioaddr + CORE_DLL_CONFIG_2)
> + & CORE_FLL_CYCLE_CNT))
I suggest you grow a local variable.
> + mclk_freq = (u32)((host->clock / TCXO_FREQ) * 8);
Is the cast necessary?
> + else
> + mclk_freq = (u32)((host->clock / TCXO_FREQ) * 4);
Ditto
> +
> + config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG_2);
> + config &= ~(0xFF << 10);
> + config |= mclk_freq << 10;
> +
> + writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG_2);
> + /* wait for 5us before enabling DLL clock */
Usually there's a barrier between writel_relaxed() and delay
because we don't know when the writel will be posted out and the
delay is there to wait for the operation to happen. Probably
should change this to be a writel() instead.
> + udelay(5);
> + }
> +
> /* Write 0 to DLL_RST bit of DLL_CONFIG register */
> config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
> config &= ~CORE_DLL_RST;
> @@ -340,6 +377,14 @@ static int msm_init_cm_dll(struct sdhci_host *host)
> config &= ~CORE_DLL_PDN;
> writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
>
> + if (msm_host->use_14lpp_dll_reset) {
> + msm_cm_dll_set_freq(host);
> + /* Enable the DLL clock */
> + config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG_2);
> + config &= ~CORE_DLL_CLOCK_DISABLE;
> + writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG_2);
> + }
> +
> /* Set DLL_EN bit to 1. */
> config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
> config |= CORE_DLL_EN;
> @@ -641,6 +686,9 @@ static int sdhci_msm_probe(struct platform_device *pdev)
> dev_dbg(&pdev->dev, "MCI Version: 0x%08x, major: 0x%04x, minor: 0x%02x\n",
> core_version, core_major, core_minor);
>
> + if ((core_major == 1) && (core_minor >= 0x42))
Why so many parenthesis?
> + msm_host->use_14lpp_dll_reset = true;
> +
> /*
--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
