devm_stmmac_probe_config_dt() already gets the PHY mode from firmware,
which is stored in plat_dat->phy_interface. Therefore, we don't need to
get it in platform code.
Set dwmac->phy_mode from plat_dat->phy_interface.
Signed-off-by: Russell King (Oracle) <rmk+kernel@xxxxxxxxxxxxxxx>
---
drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c | 6 +-----
1 file changed, 1 insertion(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
index 9c2d62d133ad..a50782994b97 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
@@ -417,11 +417,7 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
return PTR_ERR(dwmac->regs);
dwmac->dev = &pdev->dev;
- ret = of_get_phy_mode(pdev->dev.of_node, &dwmac->phy_mode);
- if (ret) {
- dev_err(&pdev->dev, "missing phy-mode property\n");
- return ret;
- }
+ dwmac->phy_mode = plat_dat->phy_interface;
/* use 2ns as fallback since this value was previously hardcoded */
if (of_property_read_u32(pdev->dev.of_node, "amlogic,tx-delay-ns",
--
2.30.2
