devm_stmmac_probe_config_dt() already gets the PHY mode from firmware,
which is stored in plat_dat->phy_interface. Therefore, we don't need to
get it in platform code.
Set gmac->interface from plat_dat->phy_interface.
Signed-off-by: Russell King (Oracle) <rmk+kernel@xxxxxxxxxxxxxxx>
---
drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c | 6 +-----
1 file changed, 1 insertion(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c
index 1b1ce2888b2e..9f098ff0ff05 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-sunxi.c
@@ -116,11 +116,7 @@ static int sun7i_gmac_probe(struct platform_device *pdev)
if (!gmac)
return -ENOMEM;
- ret = of_get_phy_mode(dev->of_node, &gmac->interface);
- if (ret && ret != -ENODEV) {
- dev_err(dev, "Can't get phy-mode\n");
- return ret;
- }
+ gmac->interface = plat_dat->phy_interface;
gmac->tx_clk = devm_clk_get(dev, "allwinner_gmac_tx");
if (IS_ERR(gmac->tx_clk)) {
--
2.30.2
