On 11/19/2024 1:28 PM, Krishna Kurapati wrote:
Enable primary USB controller on QCS615 Ride platform. The primary USB
controller is made "peripheral", as this is intended to be connected to
a host for debugging use cases.
For using the controller in host mode, changing the dr_mode and adding
appropriate pinctrl nodes to provide vbus would be sufficient.
Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/qcs615-ride.dts | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/qcs615-ride.dts b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
index ee6cab3924a6..b647c87b030b 100644
--- a/arch/arm64/boot/dts/qcom/qcs615-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
@@ -214,6 +214,29 @@ &uart0 {
status = "okay";
};
+&usb_1_hsphy {
+ vdd-supply = <&vreg_l5a>;
+ vdda-pll-supply = <&vreg_l2a>;
+ vdda-phy-dpdm-supply = <&vreg_l13a>;
+
+ status = "okay";
+};
+
From schematic, we need use the "vreg_l12a" for vdda-pll-supply.
From bindings, we also can see need 1.8V(VREG_L12A_1P8) not
2.9V(VREG_L2A_2P96):
62vdda-pll-supply:
63 description:
64 Phandle to 1.8V regulator supply to PHY refclk pll block.
+&usb_qmpphy {
+ vdda-phy-supply = <&vreg_l5a>;
+ vdda-pll-supply = <&vreg_l12a>;
+
+ status = "okay";
+};
+
+&usb_1 {
+ status = "okay";
+};
+
+&usb_1_dwc3 {
+ dr_mode = "peripheral";
+};
+
&watchdog {
clocks = <&sleep_clk>;
};
Thanks,
Song
