For QPIC V2 onwards there is a separate register to read
last code word "QPIC_NAND_READ_LOCATION_LAST_CW_n".
qcom_param_page_type_exec() is used to read only one code word
If we will configure number of code words to 1 in QPIC_NAND_DEV0_CFG0
register then QPIC controller thinks its reading the last code word,
since we are having separate register to read the last code word,
we have to configure "QPIC_NAND_READ_LOCATION_LAST_CW_n" register
to fetch data from QPIC buffer to system memory.
Also there is minimum size to fetch the data from device to QPIC buffer
is 512-bytes. If size is less than 512-bytes the data will not be
protected by ECC as per QPIC standard. So while reading onfi parameter
page from NAND device setting nandc->buf_count = 512.
Fixes: 89550beb098e ("mtd: rawnand: qcom: Implement exec_op()")
Signed-off-by: Md Sadre Alam <quic_mdalam@xxxxxxxxxxx>
---
drivers/mtd/nand/raw/qcom_nandc.c | 14 +++++++++++---
1 file changed, 11 insertions(+), 3 deletions(-)
diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 34ee8555fb8a..6487f2126833 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -2859,7 +2859,12 @@ static int qcom_param_page_type_exec(struct nand_chip *chip, const struct nand_
const struct nand_op_instr *instr = NULL;
unsigned int op_id = 0;
unsigned int len = 0;
- int ret;
+ int ret, reg_base;
+
+ reg_base = NAND_READ_LOCATION_0;
+
+ if (nandc->props->qpic_v2)
+ reg_base = NAND_READ_LOCATION_LAST_CW_0;
ret = qcom_parse_instructions(chip, subop, &q_op);
if (ret)
@@ -2911,14 +2916,17 @@ static int qcom_param_page_type_exec(struct nand_chip *chip, const struct nand_
op_id = q_op.data_instr_idx;
len = nand_subop_get_data_len(subop, op_id);
- nandc_set_read_loc(chip, 0, 0, 0, len, 1);
+ if (nandc->props->qpic_v2)
+ nandc_set_read_loc_last(chip, reg_base, 0, len, 1);
+ else
+ nandc_set_read_loc_first(chip, reg_base, 0, len, 1);
if (!nandc->props->qpic_v2) {
write_reg_dma(nandc, NAND_DEV_CMD_VLD, 1, 0);
write_reg_dma(nandc, NAND_DEV_CMD1, 1, NAND_BAM_NEXT_SGL);
}
- nandc->buf_count = len;
+ nandc->buf_count = 512;
memset(nandc->data_buffer, 0xff, nandc->buf_count);
config_nand_single_cw_page_read(chip, false, 0);
--
2.34.1
