Add the uart14 instance for X1E80100 (typically used for Bluetooth).
Signed-off-by: Stephan Gerhold <stephan.gerhold@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/x1e80100.dtsi | 53 ++++++++++++++++++++++++++++++++++
1 file changed, 53 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
index 06d27c65dc11..185bb15c2945 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi
+++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
@@ -1991,6 +1991,31 @@ &config_noc SLAVE_QUP_1 QCOM_ICC_TAG_ALWAYS>,
status = "disabled";
};
+ uart14: serial@a98000 {
+ compatible = "qcom,geni-uart";
+ reg = <0 0x00a98000 0 0x4000>;
+
+ interrupts = <GIC_SPI 806 IRQ_TYPE_LEVEL_HIGH>;
+
+ clocks = <&gcc GCC_QUPV3_WRAP1_S6_CLK>;
+ clock-names = "se";
+
+ interconnects = <&clk_virt MASTER_QUP_CORE_1 QCOM_ICC_TAG_ALWAYS
+ &clk_virt SLAVE_QUP_CORE_1 QCOM_ICC_TAG_ALWAYS>,
+ <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS
+ &config_noc SLAVE_QUP_1 QCOM_ICC_TAG_ALWAYS>;
+ interconnect-names = "qup-core",
+ "qup-config";
+
+ power-domains = <&rpmhpd RPMHPD_CX>;
+ operating-points-v2 = <&qup_opp_table_100mhz>;
+
+ pinctrl-0 = <&qup_uart14_default>;
+ pinctrl-names = "default";
+
+ status = "disabled";
+ };
+
i2c15: i2c@a9c000 {
compatible = "qcom,geni-i2c";
reg = <0 0x00a9c000 0 0x4000>;
@@ -5802,6 +5827,34 @@ rx-pins {
};
};
+ qup_uart14_default: qup-uart14-default-state {
+ cts-pins {
+ pins = "gpio56";
+ function = "qup1_se6";
+ bias-bus-hold;
+ };
+
+ rts-pins {
+ pins = "gpio57";
+ function = "qup1_se6";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ tx-pins {
+ pins = "gpio58";
+ function = "qup1_se6";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ rx-pins {
+ pins = "gpio59";
+ function = "qup1_se6";
+ bias-pull-up;
+ };
+ };
+
qup_uart21_default: qup-uart21-default-state {
tx-pins {
pins = "gpio86";
--
2.46.0
