Re: [PATCH 2/5] dt-bindings: qcom,spmi-temp-alarm: Add compatible for lite temp alarm

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 30/07/2024 01:12, Anjelique Melendez wrote:
> Add compatible "qcom,spmi-temp-alarm-lite" for Temp alarm lite
> peripherals. Temp alarm lite peripherals have two stages: warning and
> shutdown, and use a pair of registers to configure warning interrupt
> threshold temperature and an automatic hardware shutdown threshold
> temperature.
> 
> When defining thermal zone trips for a temp alarm lite device the first
> thermal zone trip is for warning alarm IRQ in HW, the second thermal
> zone trip is purely for software to perform a controlled shutdown (no HW
> support) and the third thermal zone trip is for automatic hardware
> shutdown.
> 
> Signed-off-by: Anjelique Melendez <quic_amelende@xxxxxxxxxxx>
> ---
>  .../thermal/qcom,spmi-temp-alarm.yaml         | 44 +++++++++++++++++++
>  1 file changed, 44 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/thermal/qcom,spmi-temp-alarm.yaml b/Documentation/devicetree/bindings/thermal/qcom,spmi-temp-alarm.yaml
> index f9af88d51c2d..bbf201cad16b 100644
> --- a/Documentation/devicetree/bindings/thermal/qcom,spmi-temp-alarm.yaml
> +++ b/Documentation/devicetree/bindings/thermal/qcom,spmi-temp-alarm.yaml
> @@ -22,6 +22,7 @@ properties:
>      enum:
>        - qcom,spmi-temp-alarm
>        - qcom,spmi-temp-alarm-gen2-rev2
> +      - qcom,spmi-temp-alarm-lite

Uhu, it's growing, now we have "lite". No, this is way too ambiguous.

NAK. Use PMIC compatibles.

>  
>    reg:
>      maxItems: 1
> @@ -84,3 +85,46 @@ examples:
>              };
>          };
>      };
> +
> +  - |
> +
> +    pmic {
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        pm8550b_lite_tz: pm8550b-temp-alarm-lite@c00 {

There is no difference in this example, drop.

> +            compatible = "qcom,spmi-temp-alarm-lite";
> +            reg = <0xc00>;
> +            interrupts = <0x1 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
> +            #thermal-sensor-cells = <0>;
> +        };
> +    };
> +
> +    thermal-zones {
> +        pm8550b_lite_temp_alarm: pm8550blite-thermal {

Drop as well.


Best regards,
Krzysztof





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux