Re: [PATCH 1/2] arm64: dts: qcom: sm8250: describe HS signals properly

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]


On Fri, 22 Mar 2024 at 14:03, Bryan O'Donoghue
<bryan.odonoghue@xxxxxxxxxx> wrote:
> On 22/03/2024 11:58, Dmitry Baryshkov wrote:
> > The OF graph should describe physical signals. There is no 'role switch'
> > signal between Type-C connector and the DWC3 USB controller. Instead
> > there is a HighSpeed signal lane between DWC3 controller and the USB-C
> > connector. Rename endpoints in accordance to that (this follows the
> > example lead by other plaforms, including QRB2210 RB1, QRB4210 RB2 and
> > all PMIC GLINK platforms).
> >
> > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> Hmm
> I think if you are going to change the name here, you should also do so here
> grep role_switch arch/arm64/* -r | wc -l
> 54

Oh, my. I'll take a look at the qcom platforms for v2. And funny
enough sc8180x even uses old bindings for the QMP PHY.

> Reviewed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>

With best wishes

[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux