PCIe host controller drivers are supposed to properly reset the endpoint
devices during host shutdown/reboot. Currently, Qcom driver doesn't do
anything during host shutdown/reboot, resulting in both PERST# and refclk
getting disabled at the same time. This prevents the endpoint device
firmware to properly reset the state machine. Because, if the refclk is
cutoff immediately along with PERST#, access to device specific registers
within the endpoint will result in a firmware crash.
To address this issue, let's call qcom_pcie_host_deinit() inside the
shutdown callback, that asserts PERST# and then cuts off the refclk with a
delay of 1ms, thus allowing the endpoint device firmware to properly
cleanup the state machine.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
drivers/pci/controller/dwc/pcie-qcom.c | 8 ++++++++
1 file changed, 8 insertions(+)
diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 2ce2a3bd932b..41434bc4761a 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -1618,6 +1618,13 @@ static int qcom_pcie_resume_noirq(struct device *dev)
return 0;
}
+static void qcom_pcie_shutdown(struct platform_device *pdev)
+{
+ struct qcom_pcie *pcie = platform_get_drvdata(pdev);
+
+ qcom_pcie_host_deinit(&pcie->pci->pp);
+}
+
static const struct of_device_id qcom_pcie_match[] = {
{ .compatible = "qcom,pcie-apq8064", .data = &cfg_2_1_0 },
{ .compatible = "qcom,pcie-apq8084", .data = &cfg_1_0_0 },
@@ -1670,5 +1677,6 @@ static struct platform_driver qcom_pcie_driver = {
.pm = &qcom_pcie_pm_ops,
.probe_type = PROBE_PREFER_ASYNCHRONOUS,
},
+ .shutdown = qcom_pcie_shutdown,
};
builtin_platform_driver(qcom_pcie_driver);
---
base-commit: 51459eb30f88651d3688b9e95fed0f97767ececb
change-id: 20240313-pci-qcom-shutdown-d86298186560
Best regards,
--
Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
