[PATCH net-next 0/2] net: phy: qcom: qca808x: fill in possible_interfaces

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



QCA808x does not currently fill in the possible_interfaces.

This leads to Phylink not being aware that it supports 2500Base-X as well
so in cases where it is connected to a DSA switch like MV88E6393 it will
limit that port to phy-mode set in the DTS.

That means that if SGMII is used you are limited to 1G only while if
2500Base-X was set you are limited to 2.5G only.

Populating the possible_interfaces fixes this.

Robert Marko (2):
  net: phy: qcom: qca808x: add helper for checking for 1G only model
  net: phy: qcom: qca808x: fill in possible_interfaces

 drivers/net/phy/qcom/qca808x.c | 32 +++++++++++++++++++++++++++-----
 1 file changed, 27 insertions(+), 5 deletions(-)

-- 
2.43.2





[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux