On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sm8550.dtsi | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sm8550.dtsi b/arch/arm64/boot/dts/qcom/sm8550.dtsi
index ee1ba5a8c8fc..3ee11311885f 100644
--- a/arch/arm64/boot/dts/qcom/sm8550.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8550.dtsi
@@ -1754,6 +1754,16 @@ pcie0: pcie@1c00000 {
phy-names = "pciephy";
status = "disabled";
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
pcie0_phy: phy@1c06000 {
@@ -1851,6 +1861,16 @@ pcie1: pcie@1c08000 {
phy-names = "pciephy";
status = "disabled";
+
+ pcie@0 {
+ device_type = "pci";
+ reg = <0x0 0x0 0x0 0x0 0x0>;
+ bus-range = <0x01 0xff>;
+
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+ };
};
pcie1_phy: phy@1c0e000 {
--
2.25.1
