On 06/02/2024 12:47, Krishna Kurapati wrote:
From: Andrew Halaney <ahalaney@xxxxxxxxxx> There is now support for the multiport USB controller this uses so enable it. The board only has a single port hooked up (despite it being wired up to the multiport IP on the SoC). There's also a USB 2.0 mux hooked up, which by default on boot is selected to mux properly. Grab the gpio controlling that and ensure it stays in the right position so USB 2.0 continues to be routed from the external port to the SoC. Signed-off-by: Andrew Halaney <ahalaney@xxxxxxxxxx> Co-developed-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx> Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx> --- arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts index b04f72ec097c..eed1ddc29bc1 100644 --- a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts +++ b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts @@ -503,6 +503,18 @@ &usb_2_qmpphy0 { status = "okay"; };+&usb_2 {+ pinctrl-0 = <&usb2_en>; + pinctrl-names = "default"; + + status = "okay"; +}; + +&usb_2_dwc3 { + phy-names = "usb2-port0", "usb3-port0"; + phys = <&usb_2_hsphy0>, <&usb_2_qmpphy0>; +}; + &xo_board_clk { clock-frequency = <38400000>; }; @@ -655,4 +667,13 @@ wake-pins { bias-pull-up; }; }; + + usb2_en: usb2-en-state { + /* TS3USB221A USB2.0 mux select */ + pins = "gpio24"; + function = "gpio"; + drive-strength = <2>; + bias-disable; + output-low; + }; };
Isn't gpio-hog the preferred way to describe that ? Neil
