On Thu, Feb 01, 2024 at 04:08:05PM -0600, Bjorn Andersson wrote:
> On Thu, Feb 01, 2024 at 11:05:47AM +0100, Johan Hovold wrote:
> > On Wed, Jan 31, 2024 at 07:07:26PM -0800, Bjorn Andersson wrote:
> > > + post-reset-deassert-delay-ms:
> > > + description: Time required by the device after reset has been deasserted,
> > > + before it is ready for communication.
> >
> > I know that Rob reluctantly acked this, but re-reading the commit
> > message for the commit that added support for the reset gpio to the
> > driver, and added a comment about this not having been added to the
> > devicetree binding, it becomes obvious that the latter was done on
> > purpose and that we probably should not be adding the
> > 'post-reset-deassert-delay-ms' property after all:
> >
> > For now the new "post-reset-deassert-delay-ms" property is only
> > used on x86/ACPI (non devicetree) devs. IOW it is not used in
> > actual devicetree files and the same goes for the reset GPIO.
> > The devicetree-bindings maintainers have requested properties
> > like these to not be added to the devicetree-bindings, so the
> > new property + GPIO are deliberately not added to the existing
> > devicetree-bindings.
> >
> > 2be404486c05 ("HID: i2c-hid-of: Add reset GPIO support to i2c-hid-of")
> >
> > So perhaps we should just do this properly and add a new compatible
> > property for X13s touchscreen which can be used to determine these
> > delays (e.g. for cases where some default values are insufficient).
>
> So we should add a new binding, with a device-specific compatible and
> add a reset-gpios only for that (and not the generic hid-over-i2c
> binding), and then in the i2c-hid driver encode the two delays?
Right.
> I can try to rewrite these patches, if you can provide me with a
> compatible.
My X13s doesn't have a touchscreen, but the ACPI tables says "ELAN901C".
You can look at the current binding and work with the HID and DT
maintainers to come up with something appropriate. There is one
device-specific compatible in the DT schema currently:
wacom,w9013
so something like
elan,<product>
where <product> is a name for the device with product id 0x901c (or you
use the HID product id directly somehow).
Johan
