On Wed, Jan 31, 2024 at 07:07:26PM -0800, Bjorn Andersson wrote:
> Some I2C HID devices has a reset pin and requires that some specified
> time elapses after this reset pin is deasserted, before communication
> with the device is attempted.
>
> The Linux implementation is looking for these in the "reset-gpios" and
> "post-reset-deassert-delay-ms" properties already, so use these property
> names.
>
> Reviewed-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
> Acked-by: Rob Herring <robh@xxxxxxxxxx>
> Signed-off-by: Bjorn Andersson <quic_bjorande@xxxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/input/hid-over-i2c.yaml | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/input/hid-over-i2c.yaml b/Documentation/devicetree/bindings/input/hid-over-i2c.yaml
> index 138caad96a29..f07ff4cb3d26 100644
> --- a/Documentation/devicetree/bindings/input/hid-over-i2c.yaml
> +++ b/Documentation/devicetree/bindings/input/hid-over-i2c.yaml
> @@ -50,6 +50,12 @@ properties:
> description: Time required by the device after enabling its regulators
> or powering it on, before it is ready for communication.
>
> + post-reset-deassert-delay-ms:
> + description: Time required by the device after reset has been deasserted,
> + before it is ready for communication.
I know that Rob reluctantly acked this, but re-reading the commit
message for the commit that added support for the reset gpio to the
driver, and added a comment about this not having been added to the
devicetree binding, it becomes obvious that the latter was done on
purpose and that we probably should not be adding the
'post-reset-deassert-delay-ms' property after all:
For now the new "post-reset-deassert-delay-ms" property is only
used on x86/ACPI (non devicetree) devs. IOW it is not used in
actual devicetree files and the same goes for the reset GPIO.
The devicetree-bindings maintainers have requested properties
like these to not be added to the devicetree-bindings, so the
new property + GPIO are deliberately not added to the existing
devicetree-bindings.
2be404486c05 ("HID: i2c-hid-of: Add reset GPIO support to i2c-hid-of")
So perhaps we should just do this properly and add a new compatible
property for X13s touchscreen which can be used to determine these
delays (e.g. for cases where some default values are insufficient).
Johan
