Add additional property info needed for DSIv2 DT. Signed-off-by: Archit Taneja <architt@xxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/display/msm/dsi.txt | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/display/msm/dsi.txt b/Documentation/devicetree/bindings/display/msm/dsi.txt index f344b9e..ca65a34 100644 --- a/Documentation/devicetree/bindings/display/msm/dsi.txt +++ b/Documentation/devicetree/bindings/display/msm/dsi.txt @@ -13,18 +13,25 @@ Required properties: - power-domains: Should be <&mmcc MDSS_GDSC>. - clocks: device clocks See Documentation/devicetree/bindings/clocks/clock-bindings.txt for details. -- clock-names: the following clocks are required: +- clock-names: these vary based on the DSI version. For DSI6G: * "bus_clk" * "byte_clk" + * "byte_clk_src * "core_clk" * "core_mmss_clk" * "iface_clk" * "mdp_core_clk" * "pixel_clk" + * "pixel_clk_src" + For DSIv2, we need a few more: + * "dsi_clk_src" + * "esc_clk_src" + * "src_clk" - vdd-supply: phandle to vdd regulator device node - vddio-supply: phandle to vdd-io regulator device node - vdda-supply: phandle to vdda regulator device node - qcom,dsi-phy: phandle to DSI PHY device node +- syscon-sfpb: A phandle to mmss_sfpb syscon node (only for DSIv2) Optional properties: - panel@0: Node of panel connected to this DSI controller. @@ -51,6 +58,7 @@ Required properties: * "qcom,dsi-phy-28nm-hpm" * "qcom,dsi-phy-28nm-lp" * "qcom,dsi-phy-20nm" + * "qcom,dsi-phy-28nm-8960" - reg: Physical base address and length of the registers of PLL, PHY and PHY regulator - reg-names: The names of register regions. The following regions are required: -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by The Linux Foundation -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html