Hello,
This series fixes the issue seen on Qcom EP platforms implementing the DWC
core while setting the BAR size. Currently, whatever the BAR size getting
programmed through pci_epc_set_bar() on the EP side is not reflected on the
host side during enumeration.
Debugging that issue revealed that the DWC Spec mandates asserting the DBI
CS2 register in addition to DBI CS while programming some read only and
shadow registers. So on the Qcom EP platforms, the driver needs to assert
DBI_CS2 in ELBI region before writing DBI2 registers and deassert it once
done.
This is done by implementing the write_dbi2() callback exposed by the DWC
core driver in the Qcom PCIe EP driver.
This series has been tested on Qcom SM8450 based development platform.
- Mani
Changes in v2:
- Switch to write_dbi2() callback as suggested by Sergey
Manivannan Sadhasivam (1):
PCI: qcom-ep: Implement write_dbi2() callback for writing DBI2
registers properly
drivers/pci/controller/dwc/pcie-qcom-ep.c | 17 +++++++++++++++++
1 file changed, 17 insertions(+)
--
2.25.1
