Re: [PATCH v3 6/7] drm/msm/dp: add pm_runtime_force_suspend()/resume()

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 9/27/2023 3:01 PM, Stephen Boyd wrote:
Quoting Kuogee Hsieh (2023-09-25 09:07:18)

On 9/22/2023 6:35 PM, Abhinav Kumar wrote:

Doing link training when we get hpd instead of atomic_enable() is a
design choice we have been following for a while because for the case
when link training fails in atomic_enable() and setting the link
status property as you mentioned, the compositor needs to be able to
handle that and also needs to try with a different resolution or take
some other corrective action. We have seen many compositors not able
to handle this complexity. So the design sends the hotplug to usermode
only after link training succeeds.

I do not think we should change this design unless prototyped with an
existing compositor such as chrome or android at this point.

Thanks

Abhinav


We did perform link training at atomic_enable() at eDP case since we can
assume link training will always success without link rate or link lane
being reduced.

However for external DP case, link training can not be guarantee always
success without link rate or lane being reduced as Abhinav mentioned.

In addition,  CTS (compliance test) it required to complete link
training within 10ms after hpd asserted.

Is it possible to change that timeout? I have to look around for the CTS
parameters because I'm pretty confused how it can work. What do we do if
DP wakes the system from suspend and asserts HPD? We need resume time to
be < 10ms?  That's not realistic.


No, the CTS doesnt say we need to finish link training within 10ms after HPD is asserted. It says it must be completed in 10ms after TRAINING_PATTERN_SET dpcd write.

"Wait until the Source DUT writes 00h to the TRAINING_PATTERN_SET byte of Reference Sink DPCD Link Configuration Field to indicate the end of the link training. Stop the link training timer. Verify that link training completed in 10ms or less"

That needs to be done independent of HPD so we can ignore the CTS point.


I am not sure do link training at atomic_enable() can meet this timing
requirement.


At least in the DP spec itself it doesn't require the link to be trained
within 10ms of HPD being asserted. Instead it simply recommends that the
OS start configuring the display promptly after HPD is asserted, e.g.
within 100ms. There's some strict timing on IRQ_HPD, so the driver must
read DPCD registers within 100ms of IRQ_HPD rising edge; maybe that is
what CTS is checking for?

TL;DR: I don't see why CTS should stop us from link training in
atomic_enable(). It would be beneficial to do so to make eDP and DP the
same. It would also help to report a drm connector being connected
_before_ link training so that userspace knows the link itself is the
bad part of the equation (and not that the DP connector looks
disconnected to userspace when in fact it really is connected and the
monitor is asserting HPD, just the link training failed).

Its the corrective action of the userspace when it finds link is bad is the concern as I highlighted in the other response. Just reading and resetting link_status is not enough to recover.



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux