On 9/19/2023 6:02 PM, Krzysztof Kozlowski wrote:
On 19/09/2023 09:22, Sricharan Ramabadhran wrote:
On 9/15/2023 6:15 PM, Krzysztof Kozlowski wrote:
On 15/09/2023 14:43, Krzysztof Kozlowski wrote:
On 15/09/2023 14:15, Sricharan Ramabadhran wrote:
IPQ5018 has tsens v1.0 block with 4 sensors and 1 interrupt.
Signed-off-by: Sricharan Ramabadhran <quic_srichara@xxxxxxxxxxx>
---
[v2] Sorted the compatible and removed example
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
No, unreviewed. Your driver says it is not compatible with
qcom,tsens-v1. This does not look right :/
Yes it is V1 IP, but since there is no RPM, to enable the IP/SENSORS
have to do those steps after calling init_common. Similar reason
added a new feat as well in patch #2 as well. Hence for this,
new compatible was required.
I dud not write about new or old compatible ("compatible" as noun). I
wrote that it is not compatible ("compatible" as adjective) with v1.
Ho, in that case, yes it is not compatible with V1 init and features
because of 'no rpm'. So in that case, should this be documented
as a separate version of 'V1 without rpm' ?
Regards,
Sricharan
