Re: [PATCH V2 1/4] dt-bindings: thermal: qcom-tsens: Add ipq5018 compatible

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 19/09/2023 09:22, Sricharan Ramabadhran wrote:
> 
> 
> On 9/15/2023 6:15 PM, Krzysztof Kozlowski wrote:
>> On 15/09/2023 14:43, Krzysztof Kozlowski wrote:
>>> On 15/09/2023 14:15, Sricharan Ramabadhran wrote:
>>>> IPQ5018 has tsens v1.0 block with 4 sensors and 1 interrupt.
>>>>
>>>> Signed-off-by: Sricharan Ramabadhran <quic_srichara@xxxxxxxxxxx>
>>>> ---
>>>>   [v2] Sorted the compatible and removed example
>>>>
>>>
>>> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
>>
>> No, unreviewed. Your driver says it is not compatible with
>> qcom,tsens-v1. This does not look right :/
>>
> 
>   Yes it is V1 IP, but since there is no RPM, to enable the IP/SENSORS
>   have to do those steps after calling init_common. Similar reason
>   added a new feat as well in patch #2 as well. Hence for this,
>   new compatible was required.

I dud not write about new or old compatible ("compatible" as noun). I
wrote that it is not compatible ("compatible" as adjective) with v1.

Best regards,
Krzysztof




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux