Re: [PATCH v3 5/5] arm: qcom: dts: Enable NAND node on IPQ8064 AP148 platform

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 08/03, Archit Taneja wrote:
> @@ -93,5 +115,19 @@
>  		sata@29000000 {
>  			status = "ok";
>  		};
> +
> +		nand@1ac00000 {
> +			status = "ok";
> +
> +			pinctrl-0 = <&nand_pins>;
> +			pinctrl-names = "default";
> +
> +			nand-ecc-strength = <4>;
> +			nand-bus-width = <8>;
> +		};
>  	};
>  };
> +
> +&adm_dma {
> +	status = "ok";
> +};

I think the preference is to put the full path to the device in
the dts file and then have status = "ok". So please move this
into the soc node and give the correct offset, etc. like we've
done for other nodes.

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux