All Qualcomm SoC Top Level Mode Multiplexer pin controllers have similar
capabilities regarding pin properties, thus we can just accept entire
set provided by qcom,tlmm-common.yaml schema.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
.../bindings/pinctrl/qcom,mdm9607-tlmm.yaml | 11 +----------
1 file changed, 1 insertion(+), 10 deletions(-)
diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml
index 96b598bf9a76..2aedb7e7bc8b 100644
--- a/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml
+++ b/Documentation/devicetree/bindings/pinctrl/qcom,mdm9607-tlmm.yaml
@@ -54,6 +54,7 @@ $defs:
Pinctrl node's client devices use subnodes for desired pin configuration.
Client device subnodes use below standard properties.
$ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state
+ unevaluatedProperties: false
properties:
pins:
@@ -105,19 +106,9 @@ $defs:
uim1_clk, uim1_data, uim1_present, uim1_reset, uim2_clk,
uim2_data, uim2_present, uim2_reset, uim_batt, wlan_en1, ]
- bias-disable: true
- bias-pull-down: true
- bias-pull-up: true
- drive-strength: true
- input-enable: true
- output-high: true
- output-low: true
-
required:
- pins
- additionalProperties: false
-
examples:
- |
#include <dt-bindings/interrupt-controller/arm-gic.h>
--
2.34.1
