The panel bindings expect to have only one port, thus they do not allow
to use "ports" node:
sc7180-idp.dtb: panel@0: 'ports' does not match any of the regexes: 'pinctrl-[0-9]+'
sc7180-idp.dtb: panel@0: 'port' is a required property
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sc7180-idp.dts | 11 +++--------
1 file changed, 3 insertions(+), 8 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index c3bdd3295c02..fcabbc6a897f 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -312,14 +312,9 @@ panel@0 {
reset-gpios = <&pm6150l_gpios 3 GPIO_ACTIVE_HIGH>;
- ports {
- #address-cells = <1>;
- #size-cells = <0>;
- port@0 {
- reg = <0>;
- panel0_in: endpoint {
- remote-endpoint = <&dsi0_out>;
- };
+ port {
+ panel0_in: endpoint {
+ remote-endpoint = <&dsi0_out>;
};
};
};
--
2.34.1
