On Thu, Mar 9, 2023 at 11:37 AM Bartosz Golaszewski <brgl@xxxxxxxx> wrote: > > From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx> > > This enables the QUPv3 interfaces that are exposed on the sa8775p-ride > board: I2C, SPI and the Bluetooth and GNSS UART ports. > > v4 -> v5: > - remove board-specific interrupt from UART17 in SoC dtsi > - rearrange node properties to have various *-cells properties come right > before status > - collect more tags > > v3 -> v4: > - use interconnect constants instead of magic numbers where applicable > - pad addresses in reg to 8 digits > - group pins under state nodes for UART > > v2 -> v3: > - fix the interrupt number for uart12 > - replace underscores with hyphens in DT node names (although make dtbs_check > does not raise warnings about this) > - rearrange the commits so that they're more fine-grained with separate > patches for adding nodes to dtsi and enabling them for the board > > v1 -> v2: > - uart17 is the Bluetooth port, not GNSS > - add uart12 for GNSS too in that case > > Bartosz Golaszewski (9): > arm64: dts: qcom: sa8775p: add the QUPv3 #2 node > arm64: dts: qcom: sa8775p-ride: enable QUPv3 #2 > arm64: dts: qcom: sa8775p: add the i2c18 node > arm64: dts: qcom: sa8775p-ride: enable i2c18 > arm64: dts: qcom: sa8775p: add the spi16 node > arm64: dts: qcom: sa8775p-ride: enable the SPI node > arm64: dts: qcom: sa8775p: add high-speed UART nodes > arm64: dts: qcom: sa8775p-ride: enable the GNSS UART port > arm64: dts: qcom: sa8775p-ride: enable the BT UART port > > arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 99 +++++++++++++++++++++++ > arch/arm64/boot/dts/qcom/sa8775p.dtsi | 86 ++++++++++++++++++++ > 2 files changed, 185 insertions(+) > > -- > 2.37.2 > Bjorn, I noticed you're picking up the reviewed patches. :) This series seems ready to go into your tree as well. Thanks in advance, Bartosz
