Re: [PATCH v3 05/15] dt-bindings: remoteproc: qcom,adsp: drop resets and qcom,halt-regs

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 24 Nov 2022 19:43:23 +0100, Krzysztof Kozlowski wrote:
> Some remote processors (e.g. QCS404 CDSP, SC7180 MPSS/MSS) can be brought
> to life using two different bindings:
> 1. PIL (Peripheral Image Loader)
> 2. PAS (Peripheral Authentication Service)
> 
> They still describe the same hardware - firmware load for remote
> processor - but use different methods to communicate with that
> processor.
> 
> For these SoCs, the qcom,adsp.yaml bindings were describing the PAS
> method, however for easier customization of board DTS, the bindings
> combined additional properties from PIL: reset lines, qcom,halt-regs and
> additional clocks.  The devices and Linux kernel drivers, when
> instantiated as PAS, do not use these properties, so drop them from the
> bindings.
> 
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> 
> ---
> 
> Changes since v2:
> 1. New patch
> ---
>  .../bindings/remoteproc/qcom,adsp.yaml        | 113 +-----------------
>  1 file changed, 4 insertions(+), 109 deletions(-)
> 

Acked-by: Rob Herring <robh@xxxxxxxxxx>



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [Linux for Sparc]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux